JVC MX-V508T Speaker System User Manual


 
13
English
Tuning In a Station
There are 3 ways to select a station : Manual Tuning, Auto Tuning, Preset.
Manual Tuning:
On the Unit
1. Press the FM/AM button.
2. Press the TUNING DOWN or
TUNING UP button on the MULTI
CONTROL repeatedly.
Unit/Remote Control
Steps
Explanation/Remarks
1. The radio turns on.
2. The frequency will shift from frequency to frequency
until you find the one you want.
Auto Tuning:
On the Unit
1. Press the FM/AM station.
2. Press and hold the TUNING DOWN or
TUNING UP button on the MULTI
CONTROL for a few seconds.
1. The radio turns on.
2. When a station is tuned in, the frequency stops
changing.
Preset:
On the Unit
1. Press once and release the PREV
44
44
4
P.DOWN or NEXT
¢¢
¢¢
¢ P.UP button
on the MULTI CONTROL to go to the
next preset station.
On the Remote Control
1. Press the FM/AM station.
2. Select the station by entering the preset
number in the number keys of the
Remote Control.
1. This function is only possible after presetting stations
(refer to Presetting Stations below).
1. After the preset number is selected and the number is
displayed, the broadcast frequency of the selected chan-
nel will appear on the display.
Presetting Stations
You can preset up to 30 FM stations and 15AM stations for the preset numbers.
Note : In some cases, test frequencies have been already memorized for the tuner since the factory examined the tuner preset function before
shipment. This is not a malfunction. You can preset the stations you want into memory by following the presetting method.
On the Unit
1. Press the FM/AM button.
2. Press the TUNING DOWN or
TUNING UP button on the MULTI
CONTROL.
3. Press the number keys on the Remote
Control continuously.
4. Repeat steps 1-3 for each station you
want to store to a preset number.
Notes :
Preset numbers 1 to 10:
Press the number key for the required one.
Preset numbers 11 to 20:
Press 1 to 10 after pressing +10 button.
Preset numbers 21 to 30:
Press 1 to 10 after pressing +10 button twice.
Unit/Remote Control
Steps
Explanation/Remarks
1. This will select the band (FM or AM).
2. The frequency will shift from frequency to frequency
until you find the one you want.
3. The preset number appears on the display after you have
pressed the number keys. If the key is pressed
continuously, the preset number blinks. Release the
button after the number starts to blink. This completes
the preset setting.
CAUTION: If the Unit is unplugged or if a power
failure occurs, the preset stations will be erased in a
few days. If this happens, preset the station again.
EN11-20;MX-D508T[U]/1 98.6.5, 9:45 AM13