Filter
Top Products
9
English
Creating Your Own Sound Mode — Manual Mode
You can change SEA pattern to suit your preference. These changed
setting can be stored in the MANUAL 1, 2, and 3 modes.
• There is a time limit in doing the following steps. If the setting is
cancelled before you finish, start from step 1 again.
• If you want to add the surround elements in your SEA pattern,
select one of the surround modes (D.CLUB, HALL, or
STADIUM) before starting the procedure below.
On the unitOn the unit
ONLY
::
1
Press and hold SEA CONTROL k until “SEA
CONT” appears on the display.
Current level appears.
2
Adjust the SEA pattern.
1) Press 4 ; or ¢ ; to select the
frequency range to adjust (LOW, MID,
HIGH).
2) Press 1 x or ¡ x to adjust the level (–
3 to +3) of the selected frequency range.
3) Repeat steps 1) and 2) to adjust the level of the
other frequency ranges.
3
Press SEA CONTROL k again.
4
Press 4 ; or ¢ ; to select one of the
MANUAL 1, 2 and 3 modes into which you want to
store the SEA pattern.
TUNING
SET
SEA CONTROL
SET
SEA CONTROL
SOUND MODE
PRESET
PREV
NEXT
SET
SEA CONTROL
5
Press SEA CONTROL k again.
The SOUND MODE indicator also lights up.
The SEA pattern you have created are stored into the MANUAL
mode selected in the above step.
To use your own sound mode
select MANUAL 1, 2 or 3 mode when using the sound modes. See
"Selecting the Sound Modes".
EN6-17;MX-J555V/PM6 7/8/99, 9:11 AM9