Filter
Top Products
22
English
Available DSP Modes According to the Speaker Arrangement
Available DSP modes will vary depending on how many speakers are used with this receiver.
Make sure that you have set the speaker information correctly (see page 14).
Available DSP modes
Each time you press DSP MODE on the front panel or SURROUND MODE on
the remote control, the DSP modes change as follows:
Speaker arrangements
Front
speaker
TV
Front
speaker
• 3D THEATER
• LIVE CLUB
• DANCE CLUB
• HALL
• PAVILION
• 3D ACTION (or 3D DIGITAL)
• DSP OFF (DSP mode is canceled)
TV
Center speaker
Front
speaker
Front
speaker
Rear
speaker
Rear
speaker
Front
speaker
TV
Front
speaker
Rear
speaker
Rear
speaker
Front
speaker
TV
Center speaker
Front
speaker
Each time you press DSP MODE on the front panel or SURROUND MODE on
the remote control, the DSP modes change as follows:
By pressing DSP MODE:
• THEATER (or DIG THEATER)
• LIVE CLUB
• DANCE CLUB
• HALL
• PAVILION
• 3D ACTION (or 3D DIGITAL)
• DSP OFF (DSP mode is canceled)
To activate the Surround
mode, press DOLBY/DTS/
MPEG SURROUND ON/OFF
button so that the lamp on the
button lights up.
To activate the Surround
mode, you can also use the
SURROUND ON/OFF button.
By pressing SURROUND MODE:
• DOLBY/DTS/MPEG SURROUND
(DOLBY PRO LOGIC, DOLBY
DIGITAL, DTS SURROUND, or
MPEG SURROUND)
• THEATER (or DIG THEATER)
• LIVE CLUB
• DANCE CLUB
• HALL
• PAVILION
• 3D ACTION (or 3D DIGITAL)
• DSP OFF (DSP mode is canceled)
Note on the center speaker sound when using the DAP modes:
Sounds come out of the center speaker only if the following take place at
the same time;
• If “CENTER SPK” is set to “LARGE” or “SMALL.”
• If the center channel signals come into this receiver ( C of the signal
indicators lights up — see page 10) while playing a multi-sound source
encoded with Dolby Digital, DTS Digital Surround, or MPEG
Multichannel.
In this case, you cannot adjust the center speaker output level.
EN19_30.RX-889P[US, UB]/f 99.4.12, 5:32 PM22