Filter
Top Products
7
ENGLISH
3
Tune in to a station you want while “M”
is flashing.
• If you release your finger from the button,
the manual mode will automatically turn off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 50 kHz intervals
(87.5 MHz – 108.0 MHz), in 30 KHz intervals
(65.00 MHz – 74.00 MHz) for FM and 9 kHz
intervals for AM – MW/LW) until you release
the button.
When an FM stereo broadcast is hard
to receive:
1 Press MODE to enter the functions
mode while listening to an FM stereo
broadcast.
2 Press MO (monaural), while still in
the functions mode, so that the MO
indicator lights up on the display.
Each time you press the button, the
MO indicator lights up and goes off
alternately.
When the MO indicator is lit on the display, the
sound you hear becomes monaural but the
reception will be improved.
To restore the stereo effect, press the same
button again.
Press 4
to tune
in to stations of lower
frequencies.
Press ¢
to tune
in to stations of higher
frequencies.
Storing stations in memory
You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM band
(FM1, FM2 and FM3).
1
Select the FM band (FM1 – 3) you want
to store FM stations into.
2
Press and hold both buttons for more
than 2 seconds.
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2 or FM3).
These stations are preset in the number buttons —
No.1 (lowest frequency) to No.6 (highest frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.
“SSM” appears, then disappears when automatic
preset is over.
FM
FM1 FM2
FM3
SSM
MODE
MO
EN06-08.KS-F545[EE]f 1/14/03, 5:02 PM7