Filter
Top Products
• Set “EXT IN” to “EXT IN” (see page 19 of the INSTRUCTIONS).
2
PRECAUTIONS on power supply and speaker connections:
A
Typical Connections
Before connecting: The leads of the power cord and those of the connector from the car body may be different in color.
Line out
Rear ground
terminal
CD changer jack
15 A fuse
Antenna terminal
Black
Blue with white stripe
Red
Yellow
*
3
*
2
Not included for this unit
*
3
Before checking the operation of this unit prior to
installation, this lead must be connected, otherwise power
cannot be turned on.
To metallic body or chassis of the car
Ignition switch
Fuse block
To an accessory terminal in the fuse block
To the remote lead of other equipment or
automatic antenna if any (200 mA max.)
Front speaker (left)
Front speaker (right)
Rear speaker (left)
Rear speaker (right)
Purple
Purple with black stripe
Green
Green with black stripe
Gray
Gray with black stripe
White
White with black stripe
To a live terminal in the fuse block connecting to the car battery
(bypassing the ignition switch) (constant 12 V)
Rear speakers
JVC
Amplifier
Remote lead Y-connector (not supplied for this unit)
Connecting the external amplifiers
B
Connect only the front speakers if your speaker
system is two-speaker system.
C
CD changer jack
External
component
*
5
Line Input Adapter KS-U57 (not supplied for this unit)
Connecting other external components
KS-U57
*
5
You can also connect JVC PnP through this unit using JVC SIRIUS radio adapter, KS-U100K (not
supplied).
KS-U100K
CD changer jack
Stereo mini plug
DC power plug To DC IN jack
To headphones jack
• Set “EXT IN” to “CHANGER” (see page 19 of the INSTRUCTIONS).
JVC SIRIUS
®
radio (PnP: Plug and Play) and External component
Signal cord (not supplied)
Signal cord (not supplied)
*
1
Firmly attach the ground wire to the metallic body or to the
chassis of the car—to the place not coated with paint (if
coated with paint, remove the paint before attaching the
wire). Failure to do so may cause damage to the unit.
Orange with white stripe
To car light control switch
Front speakers
Subwoofer
JVC
Amplifier
JVC DLP
JVC CD changer, JVC SIRIUS
®
radio (DLP: Down Link Processor), Apple iPod
®
, or JVC D. player
JVC CD changer
You can connect these components in series as illustrated below. The iPod
or D. player can be connnected using an interface adapter (not supplied)—KS-PD100 (for iPod) or KS-PD500 (for
D. player).
JVC CD changer
JVC DLP
or
CD changer jack
or
CD changer jack
JVC
Amplifier
Subwoofer can be connected only to the front LINE OUT terminals.
Set “L/O MODE” to “WOOFER” (See page 19 of the
INSTRUCTIONS.)
You can connect another power amplifier for front speakers.
For connecting another power amplifier, set “L/O MODE” to “FRONT” (See
page 19 of the INSTRUCTIONS.)
Signal cord
(not supplied)
Apple iPod
(separately purchased)
CAUTION :
Before connecting the external
components, make sure that the unit is
turned off.
*
4
Signal cord supplied with your JVC CD
changer or DLP
iPod is a registered trademark of Apple
Computer, Inc.
JVC D. player
(separately purchased)
Apple iPod
(separately purchased)
JVC D. player
(separately purchased)
or
or
Instal_EN_KD-S52[J]f.indd 3Instal_EN_KD-S52[J]f.indd 3 7/25/05 10:15:49 AM7/25/05 10:15:49 AM