Filter
Top Products
47
ENGLISH
To change the AM/FM channel intervals — AREA CHANGE
When this unit is shipped from the factory, the channel intervals are set to 10 kHz for AM and
200 kHz for FM (AREA US settings).
You will have to change the channel intervals when using this unit in an area other than North
America and South America.
• AREA EU: Select this when using this unit in an area other than North and South America.
(9 kHz for AM and 50 kHz (for manual tuning) / 100 kHz (for searching) for FM)
• AREA US: Select this when using this unit in North or South America. (10 kHz for AM and
200 kHz for FM)
Note:
If the channel intervals settings are changed, the following will occur.
• The names assigned to the stations will be erased from memory. To reassign the names, see “Assigning
names to the sources” on pages 48 – 50.
• The frequencies stored in the Access Commands will be changed. If this happens, store the Access
Commands again. See “Presetting the Access Commands” on pages 30 – 34.
To adjust the line input level — LINE ADJ
Adjust the line input level properly when an external component is connected to the LINE IN
plugs. When shipped from the factory, the line input level is set at level 00.
If the input level of the connected component is not high enough, increase the input level
properly. Without adjusting the line input level, you may be surprised at a loud sound when
you change from the external component to another source.
To make the front panel look flat (hiding the control panel)
— FLAT PANEL
When operating the receiver using the remote control, you can hide the control panel to make
the front panel look flat. When shipped from the factory, “FLAT OFF” is selected.
• FLAT ON: The control panel will not come out when you turn on the unit.
To use the control panel, press 4
so that the control panel comes out. If
no operation is done for about 10 seconds, it automatically goes back into the
receiver.
• FLAT OFF: You can use the control panel normally.
Note:
When “FLAT ON” is selected, you can eject a CD by holding 4 .
EN40-50.KD-LX50[J]/f 00.3.13, 4:14 PM47