Filter
Top Products
24
ENGLISH
STOP
PLAY
Operating the receiver in the Standard Word mode
In the System, 13 preset Operation Commands have been preset when shipped from the
factory.
When you speak these 13 preset words (in English), the receiver operates as you command
the receiver to do so.
To use the preset voice commands without recording your own voice, make sure
that “VOICE WORD” is set to “STANDARD” (initial setting).
If not, set it correctly by following the steps described on pages 38 and 39.
What to do
Preset Operation Command list
Command Voice Commands
No.
(Words you speak)
1 POWER OFF Turn off the receiver.
(Power off)
2 ¢ SEEK • While playing a CD, change the track number in the
(Up) increasing order.
• While listening to the radio, change the frequencies
in the increasing order.
3 4 SEEK • While playing a CD, change the track number in the
(Down) decreasing order.
• While listening to the radio, change the frequencies
in the decreasing order.
4 EJECT (Eject) Eject the CD from the receiver if any.
5 NEXT (Next) • While playing the CD changer (not supplied), change
the CD number in the increasing order.
• While listening to the radio, change the preset
channel numbers in the increasing order.
6 BACK (Back) • While playing the CD changer (not supplied), change
the CD number in the decreasing order.
• While listening to the radio, change the preset
channel numbers in the decreasing order.
7 CD (CD) Change the source to CD.
8
CHANGER (Changer)
Change the source to the CD changer if connected.
9 LINE-IN (Line in) Change the source to the external component.
10 FM (FM) Change the source to FM.
11 AM (AM) Change the source to AM.
12 VCR PLAY (Play)* Start playback on the VCR (KZ-V10) if connected.
13 VCR STOP (Stop)* Stop playback on the VCR (KZ-V10) if connected.
* Used only when the external component is selected as the source.
EN22-39.KD-LX50[J]/f 00.3.15, 4:12 PM24