JVC KD-S743R CD Player User Manual


 
26
ENGLISH
MAINTENANCE
Handling discs
This unit has been designed to reproduce CDs,
CD-Rs (Recordable), and CD-RWs (Rewritable).
This unit is not compatible with MP3 discs.
How to handle CDs
When removing a CD from its
case, press down the center
holder of the case and lift the CD
out, holding it by
the edges.
Always hold the CD by the edges. Do not touch
its recording surface.
When storing a CD into its case, gently insert
the CD around the center holder (with the printed
surface facing up).
Make sure to store CDs into the cases after use.
To keep CDs clean
A dirty CD may not play correctly. If
a CD does become dirty, wipe it
with a soft cloth in a straight line
from center to edge.
To play new CDs
New CDs may have some rough
spots around the inner and outer
edges. If such a CD is used, this
unit may reject the CD.
To remove these rough spots, rub
the edges with a pencil or ball-point pen, etc.
Moisture condensation
Moisture may condense on the lens inside the
CD player in the following cases:
After starting the heater in the car.
If it becomes very humid inside the car.
Should this occur, the CD player may
malfunction. In this case, eject the CD and leave
the unit turned on for a few hours until the
moisture evaporates.
When playing a CD-R or CD-RW
Before playing back CD-Rs or CD-RWs, read
their instructions or cautions carefully.
Use only finalized CD-Rs or CD-RWs.
Some CD-Rs or CD-RWs may not play back on
this unit because of their disc characteristics,
and for the following reasons:
Discs are dirty or scratched.
Moisture condensation on the lens inside the
unit.
The pickup lens inside the unit is dirty.
CD-RWs may require a longer readout time
since the reflectance of CD-RWs is lower than
that of regular CDs.
CD-Rs or CD-RWs are susceptible to high
temperatures or high humidity, so do not leave
them inside your car.
Do not use following CD-Rs or CD-RWs:
Discs with stickers, labels, or protective seal
stuck to the surface.
Discs on which labels can be directly printed
by an ink jet printer.
Using these discs under high temperatures or
high humidity may cause malfunctions or
damage to discs. For example,
Stickers or labels may shrink and warp a disc.
Stickers or labels may peel off so discs
cannot be ejected.
Print on discs may get sticky.
Read instructions or cautions about labels and
printable discs carefully.
CAUTIONS:
Do not insert 8 cm CDs (single CDs) into the
loading slot. (Such CDs cannot be ejected.)
Do not insert any CD of unusual shape—like a
heart or flower; otherwise, it will cause a
malfunction.
Do not expose CDs to direct sunlight or any
heat source or place them in a place subject to
high temperature and humidity. Do not leave
them in a car.
Do not use any solvent (for example,
conventional record cleaner, spray, thinner,
benzine, etc.) to clean CDs.
Center holder
Warped
disc
Sticker
Sticker
residue
Disc
Stick-on
label
EN25-27_KD-S743R[E_EX]f.p65 11/18/02, 6:40 PM26