Filter
Top Products
13
ENGLISH
For more details, consult JVC IN-CAR ENTERTAINMENT car audio dealer.
The power is not on. The sound is disrupted.
• Connect the remote input and power correctly.
• Connect the ground wire correctly to the metal part of the car.
No sound from the speaker.
• Connect the line input or speaker input cord correctly.
CAUTIONS
Ⅵ Ground wire connection
This unit requires a large amount of electrical
current during loud volume.
Peel off the coating or painting of the metal
part of the car connected to the ground wire
and screw to tighten.
If the current cannot flow smoothly, it will
cause a poor sound quality, power does not
turn on, or the sound will be cut off
momentarily.
When this happens, check the condition of
the ground wire again. If it does not improve,
change the location to connect the ground
wire.
Ⅵ When connecting to power (accessory or memory power) other than the battery.
A loud volume may cause the illumination of the car stereo to dim and the fuse may blow.
Connect the power cord only to the plus + terminal of the battery.
Ⅵ Do not cut off the fuse; otherwise, it may be short-circuited, and cause a fire.
Ⅵ Be sure to connect the "remote input" to the "remote output" of the car stereo or to the ACC
line (power) of the car.
When there is no “remote output”, connect to ACC line (power).
Ⅵ When the line output of the car stereo exceeds 2V, switch the INPUT ATT. switch to "ON".
Ⅵ This unit is designed specifically for a DC12V, minus ground vehicle. It cannot be used in a
24V vehicle such as a large truck.
Ⅵ When remote control is not used, the volume of this unit is fixed at the maximum level.
After connection, reconnect the battery negative terminal and make sure stop lamps and
others can operate normally.
TROUBLE SHOOTING
Ground wire
Peel off the coating or painting of
this section and screw to tighten.
screw (not supplied)
15A
15A
Fuse The fuse is cut off.
OK NO
CS-DA1_EN.book Page 13 Wednesday, May 23, 2007 12:09 PM