Filter
Top Products
9
ENGLISH
When using speaker input terminal
1 : TO L CHANNEL SPEAKER OUTPUT
2: TO R CHANNEL SPEAKER OUTPUT
NOTES:
• The volume of this unit is set to the maximum when the remote controller is not connected.
• If your receiver is equipped with the DSP (Digital Signal Processor), connect this unit to the front
speaker output of the receiver.
CONNECTIONS
CS-DA1
15A
Set the LPF switch to either
A110 HzB or A85 HzB according
to your preference.
White
When no remote output is equipped for
your car receiver, connect to the ACC
power.
ACC power cord
Crimp connector
Blue/White
Remote input Remote output
Left speaker
Right speaker
White/Black
Left speaker
Right speaker
JVC Car
receiver, etc.
Gray/BlackGray
White
Gray
Connect to stereo output
with maximum power 60 W
or lower (per channel).
Speaker input
cord
Speaker
input
Power cord
Yellow
⅐Connect only to the plus +
side of the battery.
Black
⅐Connect to the metal part
(such as the chassis) of the
car.
Remote controller
Fuse
TO
SPEAKER
INPUT
TO
REMOTE
OUT
POWER LEAD
GROUND
1
2
CS-DA1_EN.book Page 9 Wednesday, May 23, 2007 12:09 PM