JVC MX-K35V Stereo System User Manual


 
32
LVT0799-001A / MX-K35V / English
English
Troubleshooting
If you are having a problem with your System, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as
your dealer, for service.
Symptom Possible Cause Action
No sound is heard. Connections are incorrect, or loose.
Headphones are connected.
Check all connections and make cor-
rections. (See pages 4 to 6.)
Disconnect the headphones.
Poor radio reception The antenna is disconnected.
The AM Loop Antenna is too close
to the System.
The FM Wire Antenna is not prop-
erly extended and positioned.
Reconnect the antenna securely.
Change the position and direction of
the AM Loop Antenna.
Extend FM Wire Antenna to the best
reception position.
The disc tray does not open.
The AC power cord is not plugged in.
Tray is locked.
Plug the AC power cord.
Unlock the tray. (See page 15.)
The CD skips. The CD is dirty or scratched. Clean or replace the CD. (See page 31.)
The CD does not play. The CD is upside down. Put the CD in with the label side up.
The cassette holder cannot be opened. During tape playing, the power cord
was unplugged.
Plug in the power cord, and turn on the
System.
Unable to record. Cassette record protect tabs are re-
moved.
Cover holes on back edge of cassette
with tape.
Unable to operate the Remote Control. The path between the Remote Con-
trol and the sensor on the Unit is
blocked.
The batteries have lost their charge.
Remove the obstruction.
Replace the batteries.
The image on the TV screen is distorted.
VIDEO OUT select is not matching.
Select the correct TV system. (See page 16.)
The picture of the video CD is distorted. When you pause or skip the track, the
pictures will be distorted. This is not a
malfunction.
Operations are disabled. The built-in microprocessor has mal-
functioned due to external electrical in-
terference.
Unplug the System then plug it back in.
Specifications
Amplifier
Output Power 50 W per channel, min. RMS, at 6 ,
with no more than 10% total harmonic
distortion
Input Sensitivity/Impedance (1 kHz)
AUX IN 300 mV/50 k
Output Sensitivity/Impedance (1 kHz)
LINE OUT 500 mV/10 k
Speaker terminals 6 - 16
Phones 32 - 1 k,
0 - 15 mW/ch output into 32
MIC 2.5mV/5 k
Video Out (composite) 1.0 Vp - p (75 )
Cassette Deck Section
Frequency Response
Type I (NORMAL) 63 - 12,500 Hz
Type II (CrO
2
) 63 - 12,500 Hz
Wow And Flutter 0.15% (WRMS)
CD Player
CD Capacity 3 CDs
Dynamic Range 85 dB
Signal-To-Noise Ratio 90 dB
Wow And Flutter Unmeasurable
Tuner
FM Tuner
Tuning Range 87.5 - 108.0 MHz
AM Tuner
Tuning Range
531 - 1 629 kHz (at 9 kHz channel space)
530 - 1 710 kHz (at 10 kHz channel space)
Unit
Dimensions
270 mm
305 mm
438.5 mm (W/H/D)
Mass Approx. 7.7 kg
Speaker Specifications (each unit)
Type 3-way bass-reflex type (Magnetically
shielded)
Speaker Unit Woofer: 13.5 cm cone
1
Mid: 5cm cone
1
Tweeter: 2 cm dome
1
Power Handling Capacity
70 W
Impedance 6
Frequency Range 45 - 22,000 Hz
Sound pressure level 88 dB/wm
Dimensions 215 mm
309 mm
246 mm (W/H/D)
Mass Approx. 3.5 kg
Accessories
AM Loop Antenna (1)
Remote Control (1)
Batteries R6P (SUM-3)/AA (15F) (2)
FM Wire Antenna (1)
Video Cord (1)
AC Plug Adaptor (1)
Power Specifications
Power Requirements AC 110/127/220/230 - 240 V , adjust-
able with the voltage selector, 50/60 Hz
Power Consumption 110 W (power on mode)
Design and specifications are subject to change without notice.
MX-K35V.book Page 32 Monday, October 15, 2001 11:33 AM