JVC CA-MXSK3 Stereo System User Manual


 
– 23 –
English
You can playback type I, type II and type IV tapes without
changing any settings.
Playing Back a Tape
1
Press EJECT (0) for the deck you want to
use.
2
Put a cassette in with the exposed part of the
tape down.
3
Close the cassette holder gently.
4
Press TAPE–A 2 3 or TAPE–B 2 3 for the
deck you want to use .
The tape play starts and the
tape direction indicator or
starts flashing slowly to
indicate the tape running direction.
Each time you press the button, the tape direction
changes.
: plays the forward side.
: plays the reverse side.
If no cassette is inserted in current deck then “DECK A”
or “DECK B” and “NO TAPE” will start blinking on the
display.
When the tape plays to the end, the deck automatically
stops or reverse play depends on the setting of Reverse
Mode. (See “To play both sides repeatedly — Reverse
Mode.”)
To stop playing, press 7.
To fast forward or fast reverse, press +/¡ or 1/– (or
¢ (NEXT ¡) / 4 (PREV. 1)
on the remote control).
The tape direction indicator or starts flashing quickly on
the display.
To remove the cassette, press 0 EJECT for deck A or
EJECT 0 for deck B.
Playing Back Tapes
To play both sides repeatedly Reverse Mode
Reverse Mode works for both decks at the same time.
When it is in use, the tape automatically reverses at the end of
a side and the unit starts playing the other side of the tape,
and repeats the same process.
To use Reverse Mode, press REVERSE MODE.
The Reverse Mode indicator on the display lights up — .
To cancel Reverse Mode, press the button again so that the
Reverse Mode indicator on the display lights up — .
: Play one direction only.
: Play both sides of current deck.
: Play DECK A and DECK B repeatedly.
When Reverse Mode is on with cassettes in both decks
A and B
After the reverse side of the tape finishes playing, the tape in the
other deck starts playing.
For Deck A
For Deck B