Filter
Top Products
2
SPECIFICATIONS
Type : 2-way 2-speaker Bass-Reflex
Type
Speakers
Woofer : 13.0 cm cone × 1
Tweeter : 5.0 cm cone × 1
Power Handling Capacity : 30 W
Impedance : 6 Ω
Frequency Range : 65 Hz–20 000 Hz
Sound Pressure Level : 86 dB/W·m
Dimensions (W × H × D) : 208 mm × 323 mm × 264 mm
Mass : 3.0 kg each
Design and specifications subject to change without notice.
Connection/Anschluß/Raccordement/Aansluiting
Conexión/Collegamento/Ansluiting/Tilslutning/Liitäntä
Amplifier output terminals
Ausgang des Verstärkers
Bornes de sortie de l’amplificaterur
Uitgangsaansluitengen van de versterker
Terminales de salida de amplificador
Terminali de uscita dell’amplifcator
Utgångar på förstärkaren
Forstærkerudgangsbøsninger
Vahvistimen ulostuloliittimet
Right speaker
Rechter Lautsprecher
Enceinte de droite
Rechter spreker
Altavoz derecho
Altoparlante destro
Höger högtalare
Højre højttaler
Oikea kaiutin
Left speaker
Linker Lautsprecher
Enceinte de gauche
Linker spreker
Altavoz izquierdo
Altoparlante sinistro
Vänster högtalare
Venstre højttaler
Vasen kaiutin
Precautions
Before connecting:
• Make sure to match the polarity (ª and ·) when connecting
the speaker cords.
• Turn off the power to the amplifier before connecting the
speaker system; otherwise, the speakers may be damaged.
• The impedance of each speaker is 6 Ω.
If this does not match with the speaker impedance range
indicated on the amplifier, you cannot connect this system to
the amplifier.
• The maximum power handling capacity of the SP-MXKB25 is
30 W. Excessive input will result in abnormal noise and
possible damage.
Daily operations and maintenance:
• Be sure to turn down the volume level on the amplifier to
prevent unwanted noise before performing following
operations:
– Turning on or off other components
– Operating the amplifier
– Tuning FM stations
– Fast-forwarding a tape
– Continuously reproducing high frequency oscillation or high
pitch electronic sounds
– Connecting or disconnecting a microphone
• When using a microphone, do not aim it at the speakers or
use it near the speakers; otherwise, the howling which occurs
may damage the speakers.
• Before replacing the cartridge, always turn off the power both
to the amplifier and to the turntable; otherwise, the clicking
noise may damage the speakers.
lvt1394-001a.p65 05.4.11, 3:36 PM2