JVC CA-MXK50R Stereo System User Manual


 
7
1
Press and hold the clamp of the AM terminal
on the rear of the unit.
2
Insert the end of the AM (MW/LW) loop
antenna cord into the terminal.
If the AM (MW/LW) loop antenna wire is
covered with vinyl, remove the vinyl by
twisting it as shown in the diagram.
3
Release the finger from the clamp.
4
Turn the AM (MW/LW) loop antenna until
you have the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered wire
to the AM terminal and extend it horizontally. (The AM
(MW/LW) loop antenna must remain connected.)
For better reception of FM, MW, and LW
Make sure the antenna conductors do not touch any other
terminals and connecting cords.
Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
1
Press and hold the clamp of the speaker
terminal on the rear of the unit.
2
Insert the end of the speaker cord into the
terminal.
Match the polarity (colors): Red (+) to red (+) and black
(–) to black (–).
If the wire is covered with vinyl, remove
the vinyl by twisting it as shown in the
diagram.
3
Release the finger from the clamp.
IMPORTANT:
Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the
unit.
DO NOT connect more than one speaker to one speaker
terminal.
6-16
[ ]
SPEAKER
AM (MW/LW) antenna
Vinyl-covered wire
(not supplied)
AM (MW/LW) loop
antenna (supplied)
Connecting Speakers
From left
speakers
terminals
Speaker
cord
(red/black)
From right
speakers
terminals
ANTENNA
FM 75
AM
[ ]
Black
Red
1
2, 3
1
2, 3
Speaker
cord
(red/black)
01-10.MX-K50R[B].pm6 02.4.12, 4:41 PM7