Filter
Top Products
English
– 26 –
NEXT
PREV
Using the Timers
There are three timers available — Recording Timer, Daily
Timer, and Sleep Timer.
Before using the timers, you need to set the unit's built-in
clock. (See page 9.)
Using Daily Timer
With Daily Timer, you can wake up to your favorite music or
radio program.
How Daily Timer works
The unit automatically turns on, sets the volume level to the
preset level, and starts playing the specified source at the
turn-on time (the indicator flashes just before the turn-on-
time, and continues flashing while the timer is operating).
Then, at the turn-off time (“OFF” flashes just before the turn-
off-time), the unit automatically turns off (stands by).
The timer setting remains in memory until you change it.
• There is a time limit for performing the following steps. If
the setting is canceled before you finish, start from step 1
again.
• If you have made a mistake while setting timer, press
CANCEL. (However, this does not always work. If
CANCEL does not work, press CLOCK/TIMER repeatedly
and start from step 1 again.)
Before you start...
• When using a CD as the source to play, make sure there
is a CD in the selected tray.
• When using a tape as the source to play —
– Make sure that a tape is in the deck whose deck
indicator (A or B) is lit on the display.
– Make sure that the tape direction is correct.
• When using an external component as the source to
play, set the timer of the external component at the same
time.
On the unit ONLY:
1
Press CLOCK/TIMER until
“DAILY” appears on the display.
The DAILY (Daily Timer) indicator also starts
flashing on the display.
• Each time you press the button, the timer setting modes
change as follows:
DAILY
Canceled
ON TIME
ON TIME
Clock
setting
(See page 9.)
REC
2
Press CLOCK/TIMER again.
“ON TIME” appears for 2 seconds, then the unit
enters turn-on-time setting mode.
3
Set the turn-on-time.
1) Press 4 or ¢ to set the hour, then
press SET.
2) Press 4 or ¢ to set the minute,
then press SET.
“OFF TIME” appears for 2 seconds, then
the unit enters turn-off-time setting mode.
4
Set the turn-off-time.
1) Press 4 or ¢ to set the hour, then
press SET.
2) Press 4 or ¢ to set the minute,
then press SET.
The unit enters source selecting mode.
5
Press 4 or ¢ to select the
source to play, then press SET.
• Each time you press 4 or ¢, the
source changes as follows:
TUNER FM: tunes into a specified preset FM station. =
go to step 6.
TUNER AM: tunes into a specified preset AM station.
= go to step 6.
– CD – –: plays a track of a specified disc. = go to step
6.
TAPE: plays a tape in deck A or B. = go to step 7.
AUX: plays an external source. = go to step 7.
NEXT
PREV
NEXT
PREV
– CD – –
TUNER FM
TUNER AM
TAPE
AUX
EN21-26.MX-J770[U]/3 16/06/2000, 9:37 AM26