JVC CA-MXGT91R Stereo System User Manual


 
– 6 –
Getting Started
Supplied Accessories
Make sure that you have all the following items.
The number in the parentheses indicates the quantity of the
pieces supplied.
AM (MW/LW) loop antenna (1)
FM antenna (1)
Remote control (1)
Batteries (2)
If anything is missing, consult your dealer immediately.
Putting the Batteries into the Remote Control
Insert the batteries — R6(SUM-3)/AA(15F) — into the
remote control, by matching the polarity (+ and –) on the
batteries with the + and – markings on the battery
compartment.
When the remote control can no longer operate the unit,
replace both batteries at the same time.
DO NOT use an old battery together with a
new one.
DO NOT use different types of batteries
together.
DO NOT expose batteries to heat or flame.
DO NOT leave the batteries in the battery
compartment when you are not going to use
the remote control for an extended period of
time. Otherwise, it will be damaged from
battery leakage.
Continued
Connecting Antennas
FM antenna
1 Attach the FM antenna to the FM 75
COAXIAL terminal.
2 Extend the FM antenna.
3 Fasten it up in the position which gives you
the best reception, then fix it on the wall, etc.
About the supplied FM antenna
The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outdoor FM
antenna.
To connect an outdoor FM antenna
Before connecting it, disconnect the supplied FM antenna.
Outdoor FM antenna
(not supplied)
A 75 antenna with coaxial type connector (DIN 45325)
should be used.
FM 75
COAXIAL
ANTENNA
LOOP
AM EXT
1
3
R6(SUM-3)/AA(15F)
2
FM antenna (supplied)
FM 75
COAXIAL
ANTENNA
LOOP
AM EXT
EN01-14.CA-MXGT91R&G71R[B]f 2/26/01, 6:56 PM6