JVC CA-HXZ1 Speaker System User Manual


 
– 25 –
Using the Timers
There are three timers available—DAILY (Daily Timer), REC
(Recording Timer), and SLEEP (Sleep Timer).
Before using the timers, you need to set the clock built in the
unit. (See page 10.)
Using Daily Timer
With Daily Timer, you can be awaken with your favorite
music or radio program.
You can set the timer whether the unit is on or off; however, if
Ecology Mode is activated, you cannot set the clock while the
unit is off.
How Daily Timer actually works
The unit automatically turns on, sets the volume level to the
preset level, and starts playing the specified source when the
on-time comes (“DAILY” and the DAILY (Daily Timer)
indicator flash just before the on-time, and the DAILY (Daily
Timer) indicator continues flashing while the timer is
operating). Then, when the off-time comes (“DAILY OFF”
flashes just before the off-time), the unit automatically turns
off (on standby).
The Daily Timer works everyday automatically. If you do not
want to use the Daily Timer, turn off the Daily timer. (See
“To turn on or off Daily Timer after its setting is done” on
page 26.) The timer setting remains in memory until you
change it.
There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step
1
again.
To correct a mis-entry while setting the timer, press
CANCEL/DEMO.
Before you start...
When using a CD as the source to play—
– Make sure there is a CD on the selected disc number
tray.
When using a tape as the source to play—
– Make sure that a tape is in the cassette deck.
– Make sure that the tape direction is correct.
When using the external component as the source to
play—
Set the timer equipped on the external component at
the same time.
On the unit ONLY:
1
Press CLOCK/TIMER
repeatedly until “DAILY”
appears on the display.
(Timer) indicator lights up and the DAILY
(Daily Timer) indicator also starts flashing on the display.
Each time you press the button, the timer setting modes
change as follows:
2
Press CLOCK/TIMER again.
“TIMER” appears for 2 seconds, then the
unit enters on-time setting mode.
3
Set the on-time you want the
unit to turn on at.
1) Turn 4 / ¢ to set the hour, then
press SET/DISPLAY.
2) Turn 4 / ¢ to set the minute,
then press SET/DISPLAY.
“SET” appears for 1 second, then
the unit enters off-time setting mode.
CLOCK
/ TIMER
CLOCK
/ TIMER
P
R
E
S
E
T
SET /
DISPLAY
DAILY
Canceled
TIMER
(Daily Timer setting)
TIMER
(Recording Timer setting)
REC
Clock
setting
(The hour digits start flashing.)
DAILY
DAILY
DAILY
EN22-28.CA-HXZ1R_HXZ1[B_A]f.pm6 3/21/02, 2:46 PM25