Filter
Top Products
– 11 –
English
Listening to FM and AM Broadcasts
Tuning in a Station
1
Press FM/AM.
The unit automatically turns on and tunes in
the previously tuned station (either FM or AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Press and hold NEXT ¢ or
PREV 4 for more than 1
second.
The unit starts searching for stations and stops
when a station of sufficient signal strength is tuned in.
If a program is broadcast in stereo, the ST (stereo) indicator
lights up.
To stop searching, press NEXT ¢ or PREV 4.
When you press NEXT ¢ or PREV 4 briefly and
repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or
noisy, press FM MODE on the remote control so
that the MONO indicator lights up on the display.
Reception improves.
To restore the stereo effect, press FM MODE again so that the
MONO indicator goes off. In this stereo mode, you can hear
stereo sounds when a program is broadcasted.
Presetting Stations
You can preset 30 FM and 15 AM stations — using either
automatic presetting or manual presetting.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset function
before shipment. This is not a malfunction. You can preset the
stations you want into memory by following the presetting
method.
To preset stations automatically — Automatic Presetting
You need to preset stations separately for the FM and AM
bands.
On the remote control ONLY:
1
Press FM/AM to select the band.
• Each time you press the button, the band
alternates between FM and AM.
2
Press and hold AUTO PRESET for
more than 2 seconds.
Local stations with strong signals are searched
and stored in memory automatically.
When automatic presetting is over, the station stored in preset
number 1 is received.
3
Repeat steps 1 and 2 to store stations for the
other band.
When you cannot automatically store stations you want
Stations with weak signals cannot be detected with this automatic
presetting. To store such a station, use the manual presetting.
To preset stations manually — Manual Presetting
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step 2 again.
On the remote control ONLY:
1
Tune in the station you want to preset.
• See “Tuning in a Station.”
2
Press SET.
3
Press MULTI KEY > or MULTI
KEY < to select a preset number.
4
Press SET again.
The tuned station in step 1 is stored in the preset number
selected in step 3.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power failure
occurs
The preset stations will be erased in a few days. If this happens, preset
the stations again.
Tuning in a Preset Station
On the remote control ONLY:
1
Press FM/AM.
The unit automatically turns on and tunes in the
previously tuned station (either FM or AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Press MULTI KEY > or MULTI
KEY < to select a preset number.
EN01-11.UX-P38[US,UB,UN] 31/07/2001, 10:25 am11