Filter
Top Products
– 7 –
English
1 Connect the AM loop antenna to the AM LOOP
terminals as illustrated.
• If the AM loop antenna wire is covered with
vinyl, remove the vinyl by twisting it as shown
in the diagram.
2 Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire to
the AM EXT terminal and extend it horizontally. (The AM loop
antenna must remain connected.)
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other terminals
and connecting cords.
• Keep the antennas away from metallic parts of the unit, connecting
cords, and the AC power cord.
AM antenna
Connecting Speakers
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to red
(+) and black (–) to black (–).
3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the rear
of the unit.
Connecting Other Equipment
You can connect audio equipment — used only as a playback
device.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all connections
are complete.
Continued
Vinyl-covered wire
(not supplied)
AM loop antenna
(supplied)
1
2
Right
speaker
Left
speaker
Red
Black
Speaker
cord
Speaker
cord
EN01-11.UX-P38[US,UB,UN] 31/07/2001, 10:25 am7