Filter
Top Products
– 9 –
English
Common Operations
Turning On the Power
When you press the play button — CD 3/8 SELECT, TAPE
23, or the source selecting button — FM/AM and AUX, the
unit automatically turns on and starts playback if the source is
ready.
To turn on the unit, press STANDBY/ON.
The STANDBY lamp on the unit lights green.
To turn off the unit (on standby), press STANDBY/ON
again.
The STANDBY lamp lights red.
• The CLOCK indicator flashes on the display until you set the
built-in clock. After setting the clock, the clock time will
appear on the display while the power is off.
• A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power failure
occurs
The clock is reset to “0:00” right away, while the tuner preset stations
(see page 11) will be erased in a few days.
Setting the Clock
Before operating the unit any further, first set the clock built in
this unit. When you plug the AC power cord into the wall outlet,
the CLOCK indicator starts flashing on the display.
You can set the clock whether the unit is on or off.
• There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step 1 again.
On the unit ONLY:
1
Press CLOCK for more than 2
seconds.
The hour digits start flashing on the display.
2
Press ¢ NEXT or PREV
4 to adjust the hour, then
press CLOCK.
The minute digits start flashing on the
display.
3
Press ¢ NEXT or PREV
4 to adjust the minute, then
press CLOCK.
The CLOCK indicator remains lit on the
display.
To check the clock time
Press DISPLAY on the remote control (or CLOCK
on the unit) while playing any source.
• Each time you press the button, the source
indication and the clock time alternate on the
display.
• When you unplug the AC power cord or if a power failure occurs,
the clock loses the setting and is reset to “0:00.” You need to set the
clock again.
• The clock may gain or lose 1 to 2 minutes per month.
Setting the AM Tuner Interval Spacing
When shipped, the AM tuner interval is set to 10 kHz or
9 kHz spacing. You can change it to 10 kHz or 9 kHz spacing.
On the unit ONLY:
To select 10 kHz intervals, while holding down ¢ NEXT in
standby mode, press STANDBY/ON to turn on the power
(at the same time, the 10 kHz spacing is selected for AM
broadcast.)
To select 9 kHz intervals, while holding down PREV 4 in
standby mode, press STANDBY/ON to turn on the power.
[10 kHz Intervals] [9 kHz Intervals]
When you change the setting
The preset stations are erased. You will need to preset the stations again.
(See page 11.)
EN01-11.UX-P38[US,UB,UN] 31/07/2001, 10:25 am9