Filter
Top Products
➔➔
➔➔➔
STEP 7: Pull up and remove the cup holders.
Using a 7mm socket, remove the pair of bolts that
have been exposed.
STEP 11: As the console is tilted up, there are
more wiring harness that are exposed and that need
to be disconnected.
This now should allow the center console to be fully
removed out of the Expedition.
Cont.
From
Previous
Page
Continued on Next Page ➔
➔
STEP 8: Using a 10mm socket, remove e the bolt
that secures the wire harness. Also remove the pair
of bolts that secure the console to the floor.
STEP 12: With the console out of the Expedition,
pull down the rear cup holders. Us e a 7mm bolts
that have been exposed.
➔
STEP 13: Using a 17mm socket, remove the bolts
that secure the outside walls to the inner black con-
sole.
STEP 14: With the outside wall removed, lay the
console on its side. Using a 7mm socket, unsecured
and remove the wiring harness.
STEP 9: Once the wire harness is unsecured, dis-
connect the white plug.
STEP 10: Tilt the console up from the rear.This
will expose another harness with a white plug., dis-
connect.
SB-F-EXPDCNSL/10W3v2, JL AUDIO, Inc 2004
Sheet SKU#011106 Revision6/30/2004 Page 2
www.jlaudio.com