Filter
Top Products
Specifications:
Enclosure Type: Acoustic Suspension (Sealed)
Driver Type: 10W3v2-D2
Nominal Impedance: 4Ω
Cont. Power Handling: 300Watts
JL Audio recommends using a high quality amplifier such as the JL Audio 250/1. The diagram below shows the recommended
crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.
Included Hardware:
(3) 3/8”-16x1” Hex Bolts
(3) 3/8” Split Lock Washers
(3) 3/8” Flat Washers
(2) #6-32x1/2” Pan Head Screws
(2) #6x3/8” Flat Washers
(1) Metal L-Bracket
(1.1yd.) Backing Loop Tape
10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111
JL AUDIO 250/1
monoblock subwoofer amplifier
Amplifier Input Section
Input Sens.
Input Voltage
Low/High
Left Ch.
Right Ch.
Signal Sensing
Off/On
Output Mode
Full-Range/Low-Pass/High-Pass
Left Ch.
Right Ch.
Amp LP Filter
Mode/Slope
Off/12dB/24dB
Filter Freq. (Hz)
Bass Control
LF Boost (dB)
Off/30Hz
Infrasonic Filter
+1
+13
+3
+7
+10
Preamp Output Section
+12VDC Ground Remote
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information
about installing and tuning this amplifier.
➔
➔
STEP 31: Taking the factory storage bucket, Cut to
allow for a new depth of only 3-1/8”, from the top
edge.
Secure into the console, from STEPS 4&5.
STEP 32: Secure the storage lid from STEP 6
and front passenger seat if you did remove.
*If you did remove the passenger’s front seat, recon-
nect all the wiring and then reconnect the battery’s
negative wire.*
➔
SB-F-EXPDCNSL/10W3v2, JL AUDIO, Inc 2004
Sheet SKU#011106 Revision6/30/2004 Page 5
www.jlaudio.com
Mid/High Frequency Driver Information:
CONGRATULATIONS!
INSTALL COMPLETE.
ZR570-CSi
Front Location Driver Size:
5” x 7”/6” x 8”
Applicable JL Audio Products:
ZR,XR,VR,TR570-CSi
Rear Location Driver Size:
5” x 7”/6” x 8”
Applicable JL Audio Products:
N/A,
For proper installation, spacer rings are
required.
Cont.
From
Previous
Page
Difficulty Of Installation: