JL Audio SB-F-EXPDCNSL Speaker User Manual


  Open as PDF
of 6
 
➔
➔
➔
➔
Stealthbox
®
INSTALLATION GUIDE
SB-F-EXPDCNSL/10W3v2, JL AUDIO, Inc 2004
Sheet SKU#011106 Revision6/30/2004
Page 1
for the
SB-F-EXPDCNSL/10W3v2
(2003-Up Ford Expedition, without
AdvanceTrac®)
This Stealthbox is a product which
requires professional installation skills and
tools.
Please read this installation guide thor-
oughly before beginning the project. It
will guide you step by step through the
installation. Several of the steps in this
process may require two people to
accomplish.
It is absolutely vital that the enclosure
be properly mounted to the vehicle
according to these instructions. Failure
to mount the enclosure properly pres-
ents two problems: 1) The sub-bass
performance will suffer due to the
movement of the enclosure caused by
the force exerted by the woofer(s) and
2) A loose enclosure presents a serious
safety hazard in the event of a collision
or sudden deceleration.
Please enjoy your JL Audio Stealthbox
responsibly.
*Caution* You may be working on a Expedition
that has side air bags, located in the front seats.We
do ask for the removal of these front seats.
Disconnect the negative side of the battery and leave
for 15min.This will allow for discharge of the air bags.
Once the air bag wires have been disconnect, do not
turn the ignition on. If you do, the computer will
present an air bag fault.You may try to accomplish
this install, by not removing this seat.
STEP 1: Using a T-55 socket, unbolt the passenger side
front seat. Lean the seat back and disconnect the wire har-
ness, this does include the air bag wire.
STEP 2:
Using an 8mm socket, remove the
pair of bolts that are located on both sides of
the enclosure, towards the rear.
STEP 3:
In the center console, remove the
rubber liner. Using a 7mm socket, remove
these four bolts.
STEP 4:
With a screwdriver remove the four
screws that are found around the top edge of
the storage bucket.
STEP 5:
Using a T-20 socket, remove the pair
of bolts at the top corners of the storage
bucket.
STEP 6:
With a screwdriver, remove the six
screws that secure the console lid.
START
HERE
Continued on Next Page ➔
www.jlaudio.com
➔
➔
next