6
POWER SOURCE
This Music System is designed to operate using the supplied AC Adaptor. The Remote Control unit
operates on 1 “CR2025” Lithium battery (Included).
AC OPERATION
1. Insert the DC Plug, at the end of the AC adaptor cord into the DC JACK, at the back of the
System.
2. Plug the AC adaptor into a 120V~ 60Hz AC power outlet socket. The LCD Display will light.
3. Press the
BUTTON once to turn your System on and again to turn the System off.
Note: Only use the supplied AC adaptor.
Remarks:
In case of malfunction due to electrostatic discharge (ESD), reset the unit by unplugging and
reconnecting the AC adaptor again to resume to normal operation.
ACTIVATING THE REMOTE CONTROL
Remove the plastic insulator tag sticking out of the Battery Compartment of the Remote Control by
pulling on it. Once the tag is removed, the Remote Control will be ready for use.
BATTERY CARE
i. If the unit is not to be used for an extended period of time, remove the battery. An old or leaking
battery can cause damage to the Remote Control.
ii. Do not dispose of batteries in fire, batteries may explode or leak.
BATTERY REPLACEMENT
When the battery becomes weak, the operating distance of the Remote
Control is greatly reduced and you will need to replace the Lithium battery.
1. Remove the battery compartment from bottom of the Remote Control.
2. Install 1 “CR2025” Lithium battery with the positive side facing up.
3. Replace the battery compartment.
IMPORTANT: Be sure that the battery is installed correctly. Wrong polarity may damage the Remote
Control and void the warranty.
USING THE REMOTE CONTROLLER CORRECTLY
! Point the Remote Control at the SENSOR located on the front of the System.
! The function of the remote buttons is the same as the corresponding controls on the System.
! The performance of the infrared SENSOR may be degraded causing unreliable operation if
there is a strong ambient light source in the same room.
! The recommended effective distance for remote operation is about 10-15 feet.