Filter
Top Products
7
®
CM715K
LF
LR
RF
RR
LF–
white/black
white
LF+
RF–
gray/black
gray
RF+
LR–
green/black
green
LR+
RR–
violet/black
violet
RR+
AMP
Amplifier wiring
(See amplifier instructions)
RCA-to-RCA cables
(not supplied)
+–
Black
Yellow
Pink
Red
AMP
Orange
Filter
Box
10-amp fuse
In-line
Fuse
(2-amp)
Antenna
extender
cable
(not supplied)
Optional
CD Changer
Antenna
Jack
Back of Receiver
Dark Blue
In-line
Fuse
(2-amp)
Wiring Diagram–Advanced Installation
If you are installing new speakers or amplifiers or replacing an aftermarket installation, use this diagram.
Fuses
When replacing a fuse, make sure new
fuse is correct type and amperage. Using
an incorrect fuse could damage radio.
The CM715K uses one 10 amp (in the
filter box) and two 2 amp fast blow AGC
fuses as part of rear wiring harness.
Memory
Connect to battery or 12 volt
power source that is always live.
The radio will not work if
this wire is not connected.
Accessory
Connect to existing radio wire or
radio fuse.
Ground
Connect to ground terminal or
clean, unpainted metal part of
chassis.
Power Antenna
Connect to power antenna or
amplifier. If not used, tape bare
end of wire.
Go to “Testing” on page 8.
Dimmer
Connect to
existing
dimmer wire.
Cellular
Mute
Untitled-3 4/10/99, 7:38 PM7