JBL Speaker System Speaker System User Manual


 
INPUT
LEFT
RIGHT
AMPLIFIER
4Cl
PER CHANNEL
6.n
EACH CHANNEL
--
SerieslParallel
-
It is possible to utilize various serieslparallel 'hook-up' topologies to increase the number of loudspea
driven on an amplifier. See diag. 4 for one example of a serieslparallel hook-up topology.
Note: Mismatching the speaker impedance such that it is below the minimum impedance rating of an amplifier channel
damage the amplifier and degrade performance. If the application requires more than
2
speakers per amplifier channel
wired in parallel, a distributed line system should be considered. Also check your amplifier's manual for cautions and
recommendations.
Importance of Correct Polarity ("In-Phaselout-of-Phase")
-
When two loudspeakers are wired with opposite polarity
("out-of-phase") relative to each other, the low frequencies of the loudspeakers cancel each other, even though the speak-
ers are "working hard." Trying to correct the lack of bass with an equalizer can damage your loudspeakers
--
equalization
cannot correct polarity errors. Always make sure multiple speakers are connected in proper polarity. (See "Poor Low
Frequency Output" in the Troubleshooting section for instructions about how to detect and correct polarity problems.)
-
Distributed Line Systems (Control
"AT"
models)
-
The Control@ 25AT
&
Control@ 28AT models come equipped with
in 7011 00 volt autoformers.
These types of speakers need a line distribution amplifier.
As with conventional 8Q s
ers, simply connect the amplifier's
"t"
and
"-"
outputs directly to the red (t) and black
(-)
input jacks on the back of the
enclosure. Set the autoformer tap to your desired wattage. Unlike conventional 8fl speakers, you may connect as many
"AT" speakers as you'd like to one amplifier channel
providing that all the speaker taps do not add up to
more
than the
amplifiers power rating
(see diag. 5).
(e.g. A 100 watt amplifier channel could safely drive 13 speakers set to 7.5 watts each, i.e. 13 x 7.5
=
97.5
<
100) A
conservative rule-of-thumb is to try to keep the sum of the speaker loads (watts) under 314 of the power amp rating (e.g. A
100 watt amplifier channel will then drive 10 speaker set to 7.5 watts each, i.e. 10 x 7.5
=
75 watts).