Filter
Top Products
20
ENGLISH
Auto Preset function
When the cursor is moved to Pre-Set
on top of the preset numbers you can
activate the Auto Preset function,
clear the complete frequency list or
restore all default frequencies set by
the factory.
When the Auto Preset is selected the
tuner will scan the full FM range and
store all stations with acceptable
reception one after another on the
presets. The frequency scanned will
appear on the left lower side of the
menu while the frequency of each
station stored will be shown on the
right side of the list. When the
complete FM range is scanned or all
presets (30) are loaded with stations
the scan will stop and the first preset
be selected.
You also can stop the scan at any time
by pressing the STOP button. Stations
can be rearranged by following the
explanations in the chapter
"Rearranging the station list" on page
19.
RDS Station ID
With the help of RDS (Radio Data
System) you can show the name of
the station you are currently listening
to as well as the station names of all
other presets.
The RDS function is set to active by
default, shown by the dark blue RDS
icon at the left of the menu. In this
mode, all station names will be visible
both on the OSD menu as well as on
the Information Display on the front
panel.
If the RDS function on the left side of
the menu is inactive (light blue), you
will only see the frequency of the
current preset shown in the menu and
on the front panel display. The Station
Name line on top of the menu will
disappear, but the name of all other
stations preset will keep in the list.
Pressing STATUS on the remote will
change the front panels display´s
indication from the frequency to the
name of an RDS station or vice versa.
Surround Mode for Tuner
As with all other inputs of the
DSC 1000, you can also select your
preferred surround mode when
listening to the radio. The actual
surround mode is listed on the first
line of the tuner menu. Follow the
steps below to change the surround
format:
1. Move the cursor to the AUDIO line
on the top of the tuner menu. The
actual surround format will be
highlighted. Press enter to activate
the possible surround formats.
These will be shown in the bottom
line of the menu.
2. Move the cursor right or left, until
the desired surround format is
highlighted.
3. Press Enter to activate the change.
The setting will apply to all tuner
presets.
Note: Like with all other inputs of the
DSC 1000 the Audio mode can easily
be selected by pressing the AUDIO
button on the remote repeatedly until
the desired surround mode appears in
the first line of the OSD menu.