Jabra BT100 Headphones User Manual


 
2120
Audio Indicator Chart
Headset State Audio Indication
Volume Limit Repeated single high tone when either lower or
upper limit achieved
Low Battery Tone Five rapid high tones repeated every 20 seconds
Out of Range No audio indications,deterioration of audio quality
will alert user
Incoming Call Ring tone
Pairing Confirmation Single high tone
Establish Audio Link Series of 4 tones,low to high
Initiate Voice Dial Single low tone
Voice Tag not Recognized Dual high-low tone
End Call/Audio Link Closed Series of 4 tones,high to low
Power On/OFF No audible tone
Certification and Safety Approvals /
General Information
This product is CE marked according to the provisions of the R & TTE Directive
(99/5/EC).
Hereby,GN Netcom,declares that this product is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
For further information please consult http://www.gnnetcom.com.
Please note that this product uses radio frequency bands not harmonised within
EU.Within the EU this product is intended to be used in Austria,Belgium,
Denmark,Finland,France,Germany,Greece,Ireland.Italy,Luxembourg,The
Netherlands,Portugal,Spain, Sweden,United Kingdom and within EFTA in
Iceland,Norway and Switzerland.
Users are not permitted to make changes or modify the device in any way. Changes or
modifications not expressly approved by JABRA (GNNetcom) will void the users authority
to operate the equipment.
BLUETOOTH is a trademark owned by the Bluetooth SIG,Inc.