Filter
Top Products
13
Insignia NS-R2000 Stereo Receiver
www.insignia-products.com
Adjusting the display brightness
To adjust the display brightness:
• Press the DIMMER button to specify the
brightness of the display.
Each time this button is pressed, the
brightness changes as follows:
•ON
• dimmer
•OFF
Maintaining
To clean this receiver, wipe with a soft, dry cloth.
If the surfaces are extremely dirty, use a soft
cloth dipped in a soap and water solution or a
weak detergent solution.
• Never use alcohol, paint thinner, or benzine
to clean this receiver.
• Before using a chemically treated cloth, read
the instructions that came with the cloth
carefully.
Troubleshooting
If a problem occurs, run through the table below
before contacting Insignia.
If the problem persists, attempt to solve it by
switching the receiver off and on again. If this
fails to resolve the problem, contact Insignia.
Under no circumstances should you attempt to
repair the receiver yourself as this could void the
warranty.
Note
If the display is off, pressing any button turns the
display on.
Category Problem Possible Solution
No power 1 The AC power
cord is
disconnected.
2 Poor connection
at AC wall outlet
or the outlet is
inactive.
1 Connect the cord
securely.
2 Check the outlet
using a lamp or
another
appliance.
OR
No sound 1 The speaker
cords are
disconnected.
2 The volume is
adjusted too low.
3 The MUTE button
on the remote
control is pressed
to ON.
4 Speakers are not
switched on.
5 Incorrect
selection of the
input source.
6 Incorrect
connections
between the
components.
1 Check the
speaker
connections.
2 Adjust the
volume.
3 Press the MUTE
button to cancel
the muting effect.
4 Press the
SPEAKER A or
SPEAKER B
button to ON.
5 Select the
desired input
source correctly.
6 Make
connections
correctly.
Stations
cannot be
received
1 No antenna is
connected.
2 The desired
station frequency
is not tuned in.
3 The antenna is in
wrong position.
1 Connect an
antenna.
2 Tune in the
desired station
frequency.
3 Move the
antenna and retry
tuning.
Preset
stations
cannot be
received
1 An incorrect
station frequency
has been
memorized.
2 The memorized
stations are
cleared.
1 Memorize the
correct station
frequency.
2 Memorize the
stations again.
Poor FM
reception
1 No antenna is
connected.
2 The antenna is
not positioned for
the best
reception.
1 Connect an
antenna.
2 Change the
position of the
antenna.
Continuous
hissing
noise during
FM
reception,
especially
when a
stereo
broadcast is
received.
Weak signals. 1 Change the
position of the
antenna.
2 Install an outdoor
FM antenna.
Continuous
or
intermittent
hissing
noise during
AM
reception,
especially at
night.
Noise is caused by
motors, fluorescent
lamps, or lightning.
1 Keep the receiver
away from noise
sources.
2 Install an outdoor
AM antenna.
No
recording
1 Incorrect
selection
between the
components.
2 Incorrect
operation of each
component for
playback and
recording.
1 Make
connections
correctly.
2 Operate each
component
correctly.
Category Problem Possible Solution