Filter
Top Products
11
Insignia NS-A1111 5-CD Shelf System
www.insignia-products.com
To program CD playback:
1 With the CD player in stop mode, press the M
(memory) button. P:00 shows on the display
indicating that no tracks have been
programmed.
2 Press the search/skip button to select the
desired disc. The disc number shows in the
display.
3 Press the search/skip button again to select
the desired track. The track number shows
after the disc number in the display.
4 Press the M (memory) button again to store
the disc and track in memory.
5 Repeat steps 2 through 4 to program up to 19
additional tracks in memory.
6 To check the program, press the PLAY/
PAUSE button to start play, then press a
search/skip button to make sure that the next
programmed track plays.
To erase a CD program:
1 Press the stop button until MEMORY
disappears from the display. The display
shows the information for the current disc in
the CD changer.
OR
2 Open the disc tray by pressing the OPEN/
CLOSE button.
OR
3 Press FUNCTION to select another function.
Playing programmed tracks
1 Press the PLAY/PAUSE button to start
playback. Press during play to pause play,
then press again to resume playing.
2 Press a search/skip button to move to
another programmed track.
Maintaining your shelf
system
Cleaning the player
• Wipe with a soft cloth. If the player is very
dirty, dampen the cloth with a weak solution
of neutral detergent and water, and then wipe
clean. Do not use compressed air to remove
dust.
Caring for CDs
• Do not touch the surface of the unlabeled
side of the disc.
• Do not attach paper or tape to the surface of
the disc.
• Do not expose the disc to direct sunlight or
excessive heat.
• Do not use irregularly shaped discs (for
example: heart shaped or octagonal discs).
They may cause malfunctions.
Note
The same track can be selected more than once in the
same program. (For example, you could set a program
to play the same track 20 times.)
Note
While playing programmed tracks, the search/skip
button can only be used to select tracks that have
been programmed.
Note
While playing programmed tracks, repeat play will not
work for all discs.
Note
The memory entry (disc and track) that have been
stored appear on the display in numerical order.
FUNCTIO
N
FUNCTIO
N
FUNCTIO
N
FUNCTIO
N
NS-A1111_final_translationDTP.fm Page 11 Friday, February 17, 2006 12:09 PM