Filter
Top Products
ii
TSS-SUB4000
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install
in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as
radiators, heat registers, stoves or other
apparatus (including amplifiers) that produce
heat.
9. Do not def
eat the safety purpose of the
polarized or grounding-type plug.A polarized
plug has two blades with one wider than the
other
.A grounding-type plug has two blades
and a third grounding prong.The wide blade or
the thir
d pr
ong are provided for your safety. If
the provided plug does not fit into your outlet,
consult an electr
ician f
or r
eplacement of the
obsolete outlet.
10. Protect the power cord from being walked
on or pinched, particularly at plugs,
convenience receptacles and the point where
they exit from the apparatus.
11. Only use attachments/accessor
ies specif
ied
by the manufacturer.
12. Use only with the cart, stand, tripod, bracket
or table specified by the manufacturer or sold
with the apparatus.When a cart
is used, use caution when
moving the cart/apparatus
combination to avoid injury from
tip-over.
13. Unplug this apparatus during lightning
storms or when unused for long periods of
time.
14. Refer all servicing to qualified service
personnel. Servicing is required when the
apparatus has been damaged in any way, such
as power-supply cord or plug is damaged,
liquid has been spilled or objects have fallen
into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate
normally, or has been dropped.
15. Do not use attachments not recommended
by the product manufacturer,as they may cause
hazards.
16. This product should be operated only from
the type of power source indicated on the
marking label. If you are not sure of the type of
power supply to your home, consult your
product dealer or local power company.For
products intended to operate from battery
power, or other sources, refer to the operating
instructions.
17. If an outside antenna or cable system is
connected to the product, be sure the antenna
or cable system is grounded so as to provide
some protection a
gainst v
oltage surges and
built-up static charges.Article 810 of the
National Electrical Code,ANSI/NFPA 70,
provides information with regard to proper
grounding of the mast and supporting
structure, grounding of the lead-in wire to
an antenna discharge unit, size of grounding
conductors, location of antenna-discharge unit,
connection to grounding electrodes, and
requirements for the grounding electrode.
See Figure A.
18. An outside antenna system should not be
located in the vicinity of overhead power lines
or other electric light or power circuits, or
where it can fall into such power lines or
circuits.When installing an outside antenna
system, extreme care should be taken to keep
from touching such power lines or circuits, as
contact with them might be fatal.
19. Do not overload wall outlets, extension
cords, or integral convenience receptacles,
as this can result in a risk of fire or electric
shock.
20. Never push objects of any kind into this
product through openings, as they may touch
dangerous voltage points or short-out parts
that could result in a fire or electric shock.
Never spill liquid of any kind on the product.
21. The apparatus shall not be exposed to
dripping or splashing, and no objects filled
with liquids, such as vases, shall be placed on
the apparatus.
22. Do not attempt to service this product
yourself, as opening or removing covers may
expose you to dangerous voltage or other
hazards. Refer all servicing to qualified
service personnel.
23. When replacement parts are required, be
sure the service technician has used replace-
ment parts specified by the manufacturer or
that have the same characteristics as the
original part. Unauthorized substitutions may
result in fire, electric shock or other hazards.
24. Upon completion of any serv
ice or repairs
to this product, ask the service technician to
perform safety checks to determine that the
product is in proper operating condition.
25. The product should be mounted to a wall
or ceiling only as r
ecommended by the
manuf
acturer.
Figure A.
Example of Antenna Grounding as per
National ElectricalCode ANSI/NFPA 70
IMPORTANT SAFETY PRECAUTIONS
READ FIRST!