Filter
Top Products
OPERATIONAL INSTRUCTIONS
1. To listen to music, make sure that your iPod is playing and inserted into the built-in universal
dock correctly. It will then automatically turn ON and music will begin to play.
NOTE: If the sound seems inaudible, the i177 may not be detecting that your iPod is in the play mode. If this
happens, press the PLAY/PAUSE button on the i177 or the PLAY/PAUSE button on the Remote Control
twice for music play to begin.
2. To play music when your iPod is already in the dock and in the standby mode, press the PLAY/
PAUSE button on the i177 or the PLAY/PAUSE button on the Remote Control. When your iPod is
in the play mode, an iPod icon will appear on the LCD screen of the i177.
3. To pause music, press the PLAY/PAUSE button during the play mode. To resume playback, press
it again.
4. To adjust the volume, either rotate the VOLUME wheel on the i177, or use the VOLUME+ and
VOLUME– buttons on the remote control.
5. To go to the Next or Previous track, use the or button on the remote control. To search the
current track using high speed forward or rewind, press and hold the or buttons while
track is playing.
6. To power the unit o, press the POWER OFF button on the i177 (or on the remote control).
If your iPod is left in the built-in universal dock, it will continue to charge.
7. This unit may not operate while in the pause mode. Press the PLAY/PAUSE button on the i177
or on your iPod to initiate the play mode.
8. To play your 2nd generation iPod shue, press the iPod/shue button on unit to select the
shue play mode, the “SHUFFLE” icon will display on LCD. Insert your shue to the included
shue connector adaptor and then insert shue connector adaptor to the 3.5mm shue
connector on unit. Turn on the shue and press the PLAY/PAUSE button of shue to start play,
adjust both volume controls on your shue and i177 for desired sound level. Because all control
buttons on unit and remote control are disabled for shue, you need to operate shue itself to
control playback.
Listening to Your Favorite Songs on Your iPod
Your iPod will always be CHARGING, until reaching the FULL CHARGE mode while it is in the built-in
universal dock. Please note that this unit cannot charge your iPod without 30-pin connector.
To charge your 2nd generation iPod shue, set the switch on shue connector adaptor to CHARGE
position. The shue cannot play while charging. Set the switch to AUDIO position for shue playback.
Charging Your iPod
OPERATIONAL INSTRUCTIONS
10 | iLuv
You can still listen to the rst and second generations of iPod, or any other audio player that is
not an iPod, with the i177 by simply using the LINE-IN jack, located on the rear of the i177. Please
ensure that before using the LINE-IN jack there is no iPod in the built-in universal dock.
1. Insert the plug of the audio patch cord (not included) into the HEADPHONE or LINE-OUT jack
on your audio device, and then insert the other end of the patch cord into the LINE-IN jack,
located on the rear of the i177.
2. To get into the AUX mode, press the AUX button on the i177, or the AUX on the Remote Control,
until the AUX icon appears.
3. It is now safe to turn ON your device and enjoy the music.
4. Use the VOLUME wheel on the i177, or the Volume + and Volume – buttons on the Remote
Control to adjust the decibel level. You may also need to adjust the audio device volume.
5. To power OFF the unit, press the POWER OFF button on the i177 (or on the Remote Control).
Remember to power o your audio device as well.
Listening to Other Audio Devices
For the best FM radio clarity, fully extend the pig-tail wire antenna, located on the rear of the i177.
It is important not to alter, obstruct or attach other antennas to this wire antenna. To achieve
the best AM reception, a distance of 30 cm between the AM antenna, the unit and iPod is
recommended. Rotate the AM loop antenna to have the better reception.
1. To turn the radio on, press the BAND/RADIO button on the i177 (or on the Remote Control).
Once on, the radio frequency will appear in the lower right corner of the display.
2. To select the AM or FM, press the BAND/RADIO button again on the i177 (or on the
Remote Control).
3. To tune in a desired station, rotate the SEARCH wheel on the i177 (or use the or buttons
on the Remote Control).
4. To scan to the next clear station, press and hold the or buttons on the Remote Control
for 4 seconds. Press again to enter into the seek mode.
5. To adjust the volume, rotate the VOLUME wheel on the i177 (or the VOLUME+ and VOLUME–
buttons on the remote control).
6. To power OFF, press the POWER OFF button (or the POWER ON/OFF button on the
Remote Control).
Listening to Your Favorite Radio Station
iLuv | 11i177 | V14M14_IM_EN_09242008