Filter
Top Products
iLuv | 3i177 | V14M14_IM_EN_09242008
INTRODUCTION
GETTING STARTED
Installing the AC adapter
Installing the backup battery for clock and alarm settings
Remote control rst time use and replacing of the battery
Installing the AM loop antenna
Installing the dock adapter
Location of controls on the main unit
Location of controls on the remote control
Location of indications on the LCD screen
Setting the clock time
Setting the alarm time
OPERATIONAL INSTRUCTIONS
Outputting the audio signal to an external amplier or recording device
Listening to your favorite songs on your iPod
Charging your iPod
Listening to other audio devices
Listening to your favorite radio stations
Using the alarm function
Adjusting the brightness of the LCD screen
Setting the sleep time
MAINTENANCE & TROUBLESHOOTING GUIDE
USER SAFETY GUIDE
SPECIFICATIONS
TABLE OF CONTENTS
1
3
3
4
4
4
5
6
7
8
8
9
10
10
11
11
12
12
13
14
16
23
Locate the AC adapter jack on the back of the unit. Insert the AC adapter cable into the jack, and
plug into the wall outlet.
Installing the AC Adapter
GETTING STARTED
In order to oer consistent clock settings and alarm functions, the i177 uses a backup battery
system. This means that in the event of a power failure, all the settings of i177 will remain saved. For
example, after the installation of the Backup Battery, the AC cord is disconnected or a power failure
occurs, the display will not remain lit, but the time, date and alarm settings will be temporarily
maintained. The alarm, however, will not sound when the i177 is powered only by the Backup
Battery. To install Backup Battery, follow the instructions below:
1. Make sure the connection between the AC adapter and the unit is secure. This is important
because during battery replacement it is possible for all settings to be lost if clock and alarm
have already been set.
2. Locate the battery compartment on the bottom of the unit and open.
3. Insert 2 “AA” batteries, following the correct polarity (+/-) drawings inside the battery
compartment. For longer battery life, alkaline batteries are suggested. Please note that new
and used batteries should not be mixed. Likewise, alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries should not be used together.
4. Secure the battery compartment by closing the cover.
Installing the Backup Battery for Clock and Alarm Settings
2 | iLuv
Important Notes on Batteries
To prevent battery leakage, which may result in bodily injury, property damage or
damage to the unit, follow these instructions.
· Install all batteries correctly according to the polarity (+/–) as marked on the unit.
· Do not mix old and new batteries, carbon and alkaline, etc.
· Remove batteries from the unit when the device will not be used for an extended
period of time.
Please dispose the used batteries properly according to your local
government regulations.