Filter
Top Products
13
Main Unit Installation
Please leave adequate space around the unit in
order to avoid increasing the internal temperature.
Make sure not to block any ventilation holes.
Do not install the unit in a small space such as
inside a cabinet, closet or box without adequate
ventilation.
Leave at least 10cm (4") of clearance from each
side of the unit and from the top of the unit to
ceiling.
PREPARATION
Remote Control Battery Installation
CAUTION
Risk of corrosion or battery leakage. Tampering with batteries may result in
physical injury and/or property damage including re.
Never mix used and new batteries in the device.
Replace all the batteries in the device at the same time.
Remove the batteries if the remote control is not going to be used for an extended period of time.
To avoid possible malfunction, read the following instructions and handle
the remote control correctly.
Do not drop or allow impact to affect the remote control.
Do not spill water or any liquid on the remote control.
Do not place the remote control on a wet surface.
Do not place the remote control under direct sunlight or near sources of excessive heat.
Use the remote control within a distance of
about 5m (16’) from the front of the unit’s
remote control sensor and within an angle of
about 30 degrees on both sides.
Handling the Remote Control
The remote control operates on 2 “AAA” batteries.
1.
Open the battery compartment cover
Push and pull open the battery compartment cover
on the backside in the direction of the arrow, and
remove the cover.
2. Install the batteries
Install 2 “AAA” batteries (included)
making sure the polarities match the
indication inside the compartment.
3. Close the battery
compartment cover
Make sure the tabs rest in
the corresponding holes
a n d p u s h d o w n t h e
compartment cover until it
clicks shut.
Within 30
degrees
About 5m (16’)
About 3m (10’)
Within 30
degrees
About 3m (10’)
10 cm.
10 cm.
10 cm.
10 cm.
10 cm.
10 cm.
NOTE
Aim the Remote Control to the Monitor
IR sensor, Monitor will transmit the commands to
the A/V Center trough their HDMI connection.