Filter
Top Products
36
6 More recording features
Monitoring a
source
When recording, or in record-
pause mode, the source signal is
always available for monitoring
through a connected audio
system or through a pair of
headphones plugged into the
CDR–830’s phones jack. Even if
you’re not recording, you can still
monitor—useful for cueing up for
the next recording and also for
checking that tracks are starting
in the proper places during
automatic track numbering.
1 Start the source
component playing.
Make sure that the input selector
is set to the correct input.
MONITOR
INPUT
SELECTOR
AUTO
MANUAL
TITLE/MODE
TRACK NO.
WRITE
DISPLAY
FINALIZEERASE
SCROLL
CD TEXT
2,3
2 Press MONITOR.
The indicator above the MONITOR
button lights up.
• When automatic track
numbering has been selected,
the
TRACK indicator will light
for 2 seconds at track start
points. See
Automatically
numbering tracks
on page 33
if you find the recorder can’t
recognize the gaps between
tracks.
• When monitoring through a
digital output, you cannot hear
changes you make in the
recording level or balance.
3 To switch off monitoring,
press MONITOR again.
The monitor indicator switches
off.
To establish the
copy-bit (SCMS)
setting
These settings control the
number of generations of digital
copies that can be made from the
recorded disc. Use this function
to set whether the disc can be
copied unlimited times, once, or
not at all. The status of the copy-
bit in the incoming digital signal is
ignored and the copy-bit setting
on the recorded disc is only set
by this menu function.
1 Press MENU/DELETE.
2 Turn the jog dial until COPY
: PERMIT appears in the
display, then press to
ENTER.
3 Use the jog dial (
44
44
4 and
¢¢
¢¢
¢ on the remote) to
select the copy flag setting.
The default setting is copy permit.
Turn the dial to cycle through the
following settings:
COPY : PERMIT
– Permits unlimited copies
COPY : ONCE
– Permits one copy only
COPY : INHIBT
– Restricts all copying
• When the original setting is
changed, a question mark (?)
blinks next to the selected
option.
4 Press the jog dial (ENTER)
to confirm the setting.
The question mark disappears
from the display and the new
setting is confirmed.
DIGITAL
REC LEVEL
ANALOG
REC LEVEL
MENU/
DELETE
TEXT
SYNCHRO
PROFESSIONAL