Filter
Top Products
Introduction
The Host Interface Library for the HP E1433A is a set of functions that
allow you to program the register-based HP E1433A at a higher level than
register reads and writes. The library allows groups of HP E1433As to be
set up and programmed as if they were one entity.
The HP E1433A uses the same software as the HP E1432A 16 Channel 51.2
kSa/sec Digitizer plus DSP.
Two version of the Host Interface Library are available. One is the HP-UX
C-Language Host Interface Library which uses SICL (the Standard
Instrument Interface Library) to communicate to the HP E1433A hardware.
The other is the VXIplug&play Library which communicates with the
hardware using the VXIplug&play standard. This chapter covers the
C-Language version. If you are using the VXIplug&play version, you will not
need this chapter. Instead, see the chapters titled “Getting Started With
the HP E1433A” and “Using the HP E1433A”
The library includes routines to set up and query parameters, start and stop
measurements, read and write data, and control interrupts. Routines to aid
debugging and perform low-level I/O are also included.
For information on diagnostics see the chapter titled “Troubleshooting the
HP E1433A.”
Almost all functions in this library return 0 if they complete successfully
and a negative error number if there is a problem. The return value of the
function should always be checked and appropriate action taken for
non-zero values. See the on-line man pages for more information on error
messages.
HP E1433A User's Guide
The C-Language Host Interface Library
4-2