Filter
Top Products
6
REAR-PANEL CONNECTIONS
CONTROLLER
FM Antenna Terminal: Connect the included FM antenna wire
here.
DAB Antenna Terminal (MAS 110 Only): Connect the
included DAB antenna wire lead here to enjoy programming from digital
DAB, DAB+ or T-DMB-Audio radio stations available in your area.
USB Port B: Connect a compatible USB device here to enjoy play-
back of audio MP3 or WMA files. Although most USB flash and hard-disk
drives in the FAT32 file format, as well as many MP3 players, are com-
patible with the MAS 100 and MAS 110 systems, due to the wide variety
of manufacturers, playback cannot be guaranteed. Do not connect an
iPod or iPhone to this port. Do not connect a personal computer or any
peripherals to this port.
Optical 1/2 and Coaxial 1/2 Digital Audio Inputs:
Connect a source device’s optical or coaxial digital audio output to the
corresponding input. Only the PCM uncompressed format is supported.
TV and AUX Analog Audio Inputs: Connect the
analog audio outputs of a television or any source device to enjoy play-
back through the high-performance MAS system.
Phono Input: Connect the outputs of a moving magnet
(MM) type turntable to this input. Do not connect any other type of turn-
table to this input, and do not connect the outputs of
an MM-type turntable to any other analog audio inputs on the MAS 100
or MAS 110 without using a phono preamp, available separately from
many electronics stores.
Input: To enjoy playback of audio materials stored on a
compatible iPod (see page 4), connect The Bridge II dock (included with
some versions of the MAS 110 system; available separately for the MAS
100 and some versions of the MAS 110 systems). Make sure the insert
for The Bridge II is installed, and install the appropriate dock adapter for
your iPod within the insert, as shown in Figure 1 on page 10.
Analog Audio Outputs: Connect these outputs to the analog
audio inputs of an audio recorder. When a source
connected to the MAS system is playing, the signal will be
available at these outputs for recording.
Coaxial Digital Audio Output: Connect this output
to the coaxial digital audio input of a digital audio recorder. When a
source connected to the MAS system is playing, the signal will be avail-
able at this output for recording.
NOTES:
• The MAS system does not convert analog sources to the
digital domain, or digital sources to the analog domain
for recording.
• It is the user’s responsibility to comply with all laws
pertaining to the copying of audio materials.
Output to Amplifier: Connect the included ribbon cable to this
connector and to the corresponding connector on the MAS amplifier.
This cable passes audio signals from the controller to the amplifier, and
it transfers DC power from the amplifier to the controller. If this cable
is ever damaged, do not use it, and contact Harman Kardon, Inc., for a
replacement.
RS-232 Serial Port: This port is used only for system upgrades.
Do not connect it to any devices unless instructed to do so at the time a
system upgrade is released.
Update Switch: This switch is used only for system upgrades.
Leave it in the “N” position for normal operation unless instructed to
switch it to the “U” position to install a system update.
FM Antenna
Terminal
Optical 1/2 Digital
Audio Inputs
RS-232
Serial Port
DAB Antenna
Terminal
(MAS 110 only)
Output to
Amplifier
Coaxial Digital
Audio Output
The Bridge II
Input
Coaxial 1/2 Digital
Audio Inputs
Analog Audio
Outputs
TV and AUX
Analog Audio
Inputs
USB Port
Phono Input
Update Switch