Filter
Top Products
BASIC OPERATION
1 Press the POWER button to turn
the power ON, the display panel
will then light up.
•When using the POWER button
on the remote control turn the unit
off, the unit will go into STANDBY
mode.
2 Select the desired program source
with the INPUT FUNCTION
SELECTOR buttons and the
selected input function appears in
the display.
3 When the TAPE MONITOR button
is set to ON so that the TAPE
indicator lights up, the selected
program source cannot be heard
from the speakers.
To listen to a program source
other than cassette deck be sure
to set the TAPE MONITOR button
to OFF.
4 Adjust the volume to a comfortable
listening level with the VOLUME
control or VOLUME UP/DOWN
buttons on the remote control.
5 For private listening, insert a 1/4
inch plug of the headphone into the
HEADPHONE jack.
•When the headphones are
plugged, sound from the
speakers is cut off.
LISTENING TO BROADCASTS
You can use auto, manual or preset
tuning to select a radio station.
AUTO TUNING
If broadcast signals are strong and
there is no interference, auto tuning is
possible.
1 Press the FM or AM button to
select the desired band.
2 Press the SEEK STEREO button
and AUTO will illuminate in the
display.
3 Press the TUNE UP/DOWN button.
Tuning will start automatically and
stop at a broadcast station
frequency with sufficient signal
strength.
MANUAL TUNING
Auto tuning may be impossible if the
broadcast signal is weak. If so, use
manual tuning.
1 Press the FM or AM button to
select the desired band.
2 Press the SEEK/STEREO button
and AUTO will go out in the display.
3 Press the UP or DOWN
TUNE/PRESET button until the
desired station frequency is
reached.
•Each time the button is pressed,
the frequency changes by a step.
•When the button is kept pressed,
the frequency changes
continuously in sequence.
PRESET TUNING
The receiver has a memory for up to
30 preset stations.
If the station frequencies are stored in
this memory, they can be tuned in by
a simplified procedure.
MANUAL PRESETTING
Up to 30 stations can be preset at
random, regardless of the reception
band.
1 Tune in the station to be
memorized using the auto or
manual tuning.
2 Press the MEMORY button, then
the MEMORY indicator lights up for
5 seconds.
3 Select the channel number with the
UP or DOWN TUNE/PRESET
NUMERIC buttons on the remote
while the MEMORY indicator is lit,
then the selected channel number
lights up.
4 Press the MEMORY button to
memorize the station.
•When using the NUMERIC
buttons on the remote, the station
is memorized without pressing
the MEMORY button again.
•When selecting one digit channel
number with the NUMERIC
buttons, press the corresponding
number without “0”.
5 Repeat steps 1 to 4 to preset other
stations.
7
Operation
ENGLISH
HK3250 engelsk 11/01/98 14:28 Side 7