Filter
Top Products
1. FM INDOOR ANTENNA
Connect the supplied antenna (the
wire lead) to a 300Ω/75Ω adapter and
connect the adapter to the 75Ω FM
antenna terminal, as shown in the
Rear Panel Connection Diagram.
Change the position of the antenna
until you get the best reception of your
favorite stations.
2. FM OUTDOOR ANTENNA
An outdoor FM antenna may be used
to further improve the quality of
reception. Disconnect the indoor
antenna before replacing it with the
outdoor one. A 75Ω/300Ω adaptor
must be used.
3. AM LOOP ANTENNA
Tune in your favorite AM station and
position the loop antenna for best
reception. Try other stations and find
the position that gives the best overall
reception. When this unit is mounted
in a rack or placed on a shelf with
sufficient space behind, hang the
antenna on a wall in the direction
which gives the best reception.
NOTE: If noise is heard during AM
reception, move the antenna for better
reception. To prevent undesired noise,
the AM LOOP ANTENNA should be
located away from the remote control
cord over 12 inches (30cm).
4. TV / AUX INPUT JACKS
This input is provided for any source
you want to hear. An additional
compact disc player, tape recorder,
TV video cassette recorder (VCR), etc.
can be plugged into these jacks.
5. CD INPUT JACKS
Connect the output cables of a
compact disc player to these jacks.
6. TAPE PLAY JACKS
Connect the line output of your
CASSETTE DECK to these jacks.
7. TAPE REC JACKS
Connect the line input of your
CASSETTE DECK to these jacks.
8. VCR2 INPUT JACKS
Connect these jacks to the
corresponding AUDIO OUTPUT jacks
of your TV (if available) or VCR.
9. VCR1 INPUT (PLAY) JACKS
Connect these jacks to the
corresponding AUDIO OUTPUT jacks
of a VCR.
10. VCR1 OUTPUT (REC)
JACKS
Connect these jacks to the
corresponding AUDIO INPUT jacks of
a VCR.
11. REMOTE CONTROL OUT
JACK
Connect this jack to the REMOTE IN
jack on a Harman Kardon component.
Use one of the accessory mini-plug
cables.
You can control many other Harman
Kardon components in your system
using the HK3250 remote
commander.
12. REMOTE CONTROL IN
JACK
Connect a Harman Kardon HE 1000
remote I.R. sensor to this jack. You
can operate the unit by remote
commander through the adaptor. It is
convenient when the unit is located in
a separate room.
13. PRE OUT JACKS
When a separate power amplifier is
used to drive the speakers, connect
the power amplifier input to these
jacks.
14. SPEAKER TERMINALS
Two pair of speaker terminals are
provided. For primary speakers
connect the left (L) and right (R)
speakers to the speaker 1 terminals.
Make sure that the positive (+) and
negative (-) terminals on the speaker
are connected to the corresponding
terminals on the receiver. If you wish
to use another pair of speakers with
the receiver, connect this pair to the
speaker 2 terminals.
15. AC INPUT CORD
Plug this cord in AC outlet on a wall.
16. AC SWITCHED OUTLET
This outlet provides AC power. The
AC power is switched by the power
button. Use this outlet for a CD player
or a cassette deck.
PLEASE NOTE: Do not plug irons or
toasters or other products with high
power consumption into these
outlets.
6
Rear Panel Connections
ENGLISH
AM LOOP ANTENNA SETTING
Stand and place it on a shelf
or hang it on a wall.
LEG
HK3250 engelsk 11/01/98 14:28 Side 6