Filter
Top Products
20
Selecting the Tuner input source
1 Press »TUNER/BAND« to select the input source.
– The most recently selected station is activated (Last Station
Memory).
– Display: e.g. »FM 100.60« or »ENERGY«.
Selecting a preset position
1 Press »TUNER/BAND« to select the frequency band (FM or
MW).
2 Select the preset position in steps by pressing
»
$s6MEM
5aaa
«.
– Display: »PROG« and, for example, »P02« and the frequency
or the station name.
Stereo/mono reception
When the hi-fi system receives FM stereo stations, »ɳ« appears in
the display. If the signal from the FM stereo station is weak, you can
improve the sound quality by switching to mono reception.
1 Press »FM MODE« on the remote control to switch to mono
reception.
– Display: »
ɳ« disappears.
2 To switch back to FM stereo, press »FM MODE« on the remote
control.
– Display: »
ɳ«.
Note:
The mono or stereo setting is saved when you store a station as
a preset.
Automatic station search
By starting the automatic station search, you can delete all the
existing preset stations and replace them with new stations at the
same time.
1 Start the automatic search in tuner mode by pressing and
holding down »PROG./RAND./TIME«.
– After the search has finished, you will hear the station stored
at preset position 01.
Note:
The automatic station search can be interrupted by briefly
pressing »
7«.
TUNER MODE
_______________________________________
P15
ENERGY
f
PROG
!
P02
VILRADIO
f
PROG
!
P02
FANTASY
f
PROG
!
P03
FM 93.25
MHz
PROG