Garmin GTR 200 Radio User Manual


 
sales receipt from the original retailer is required. Garmin will not replace missing
Components from any package purchased through an online auction.
International Purchases: A separate warranty may be provided by international
distributors for devices purchased outside the United States depending on the
country. If applicable, this warranty is provided by the local in-country distributor
and this distributor provides local service for your device. Distributor warranties
are only valid in the area of intended distribution. Devices purchased in the United
States or Canada must be returned to the Garmin service center in the United
Kingdom, the United States, Canada, or Taiwan for service.
To obtain warranty service, contact your local Garmin Authorized Service Center.
For assistance in locating a Service Center near you, visit the Garmin web site at
http://www.garmin.com or contact Garmin Customer Service at 866-739-5687.
WARNING: For safety reasons, GTR 200 operational procedures must
be learned on the ground.
CAUTION: The Garmin GTR 200 does not contain any user-serviceable
parts. Repairs should only be made by an authorized Garmin service
center. Unauthorized repairs or modifications could void both the
warranty and the pilot’s authority to operate this device under FAA/
FCC regulations.
CAUTION: The GTR 200 display uses a lens coated with a special
anti-reflective coating that is very sensitive to skin oils, waxes, and
abrasive cleaners. CLEANERS CONTAINING AMMONIA WILL HARM
THE ANTI-REFLECTIVE COATING. It is very important to clean the
lens using a clean, lint-free cloth and an eyeglass lens cleaner that is
specified as safe for anti-reflective coatings.
NOTE: All visual depictions contained within this document, including
screen images of the GTR 200 bezel and displays, are subject to change
and may not reflect the most current GTR 200 software. Depictions of
equipment may differ slightly from the actual equipment.
NOTE: This device Complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.