Fujitsu TD725SW Speaker User Manual


 
-
27
-
Care
Before attending to the care of the subwoofer,
be sure to turn the power OFF and remove the
power cable plug from the power outlet.
Remove any soiling on the subwoofer by
wiping lightly with a soft cloth.
If the soiling is severe, wet the cloth with
water, wring it out well, wipe the soiling off,
and then finish with a dry cloth.
Do not wipe the subwoofer with benzene or
any thinner.
This could damage the surface of the cabinet.
If the subwoofer operates abnormally
If, during use, the subwoofer is subjected to
strong external noise (abnormal power supply
voltage caused by excessive impact, static
electricity, or a lightning strike), or it is handled
incorrectly, it may stop operating correctly.
If this happens, turn the POWER button OFF.
Upon turning the power back ON, check that
operation is normal.
If the fault remains, please contact Fujitsu Ten.
Thinner
Gasoline
Specifications
Please note that the specifications and
external appearance of the subwoofer are
subject to change without notice for the sake
of improvement.
Rated output :
500 W
(T.H.D. of 1%)
Total high frequency distortion factor :
0.05%
(at 50 Hz and half the rated output)
Playing frequency characteristics :
20 Hz – 200 Hz
(BASS MODE, L. P. F. 200Hz)
Input sensitivity:
40 mVrms (50 Hz)
Signal to noise ratio :
95 dB or higher
Input impedance :
10 k ohms
External dimensions :
W517 x H473 x D503 (mm)
[W20
1
/4" x H18
5
/8" x D19
3
/4"]
(including projections)
W473 x H473 x D473 (mm)
[W18
3
/4" x H18
3
/4" x D18
3
/4"]
(dimensions of the box)
Input voltage :
100 V (Japan)
120 V (USA)
230 V (Europe)
Power consumption :
65 W
Speaker opening diameter :
25 cm x 2
10" x 2]
Weight :
Approx. 42.5 kg [93
1
/2 lbs]
Care and Specifications
ENGLISH