Filter
Top Products
20
USING THE DSP8000
LOUDSPEAKERS
Selecting a source
When not playing, the DSP8000 loudspeakers should be left in the standby
state. This uses a negligible amount of electricity, but ensures that the
components of the loudspeakers operate at maximum efficiency from the
moment you start.
If you are not going to use the DSP8000 loudspeakers for several days you
should switch each unit completely off at the back panel, and disconnect it
from the AC power supply.
To select a source
• Press the appropriate source key on the remote; eg Radio.
This will bring the DSP8000 loudspeakers out of standby, and the displays
will show the currently selected source and volume setting.
For example:
Radio 65
By default the 12 sources shown below are available.
As standard, all the sources are set to select the D1 digital input. To select
the D2 input, see To configure a source, page 29.
Source Label Source Label
CD CD CDR CDR
Radio Radio Cable Cable
LP LP DVD DVD
TV TV Cable Cable
Tape1 Tape1 VCR1 VCR1
Tape2 Tape2 LD LDisc
To switch to standby
• Press Off on the remote.
The loudspeakers will switch to standby and
the displays will show:
.