Filter
Top Products
6
INTRODUCTION
Specification
Digital inputs and outputs
•
2 x cable digital inputs, 75Ω, IEC958, 44.1-96kHz. FIFO locks at 44.1, 48,
88.2, or 96kHz ± 150ppm, PCM or MHR encoding.
•
176.4kHz or 192kHz supported with special firmware and cabling; details
available on request.
•
1 x cable digital output, 75Ω, IEC958, providing a copy of the selected
input.
Signal processing
•
2 x Motorola 56366 running at 100MHz.
•
4 x 192kHz/24-bit Delta-Sigma DACs.
•
Crossovers linear-phase ±30º at 200Hz and 2.6kHz.
Output stages
•
Power amplifiers: Complementary bipolar design, with output-stage
error correction and low feedback design.
•
Bass: 3 x 150W RMS.
•
Mid: 100W RMS.
•
Treble: 100W RMS.
Acoustic
•
3 way.
•
Closed bass enclosure.
•
Separate mid/top plywood cabinet.
•
Bass drive unit: 6 x 200mm (8") high-efficiency long-throw custom
drivers.
•
Mid drive unit: 1 x 160mm (6") custom driver.
•
Treble drive unit: 1 x 25mm (1") Meridian piston in short horn,
composite dome with silver voice-coil.
Characteristics
•
Distortion typically <0.01%, or <0.02% up to full power at all
frequencies.
•
Noise and hum <-94dBr at all volume settings.
•
Acoustic output typically >115dB spl @ 1m.
•
Acoustic noise <15dB spl @ 1m.
•
Frequency response in room response within 3dB, 25Hz-35kHz.
Control
•
2 x Meridian Comms.
•
9-pin D connector for RS232 PC setup and control, null modem, 9600
baud, 2N1, no handshake.