Filter
Top Products
Extron TP Transmitters • Installation and Operation
Extron TP Transmitters • Installation and Operation
Installation and Operation, cont’d
Composite video and stereo audio
The TP T 15HD AV (figure 2-15) accepts and transmits
composite video and stereo audio.
6
RGB/video switch (TP T 468 only) — Configures the
transmitter for RGB or component/S-video/composite video.
See “Video DIP switch,” earlier in this chapter.
7
Video connector — Connect composite video to this RCA
connector. Digital audio can also be connected to this connector.
8
Audio input connectors — Connect left and right stereo audio
to these RCA connectors.
Input only analog, line level audio signals on these
connectors.
RGBHV video
The TP T BNC DA4 (figure 2-18) accepts and transmits RGBHV,
RGBS, RGsB, component video, S-video, and composite video.
OUTPUT 1 OUTPUT 2 OUTPUT 3 OUTPUT 4
INPUT
R G B H/HV V
POWER
15V .5A DC
8 999
9
11
Figure 2-18 — Installation features, TP T BNC DA4
9
Video connector — Connect the desired video input device to
the rear panel input BNCs. Transmission of component video,
S-video, or composite video requires that internal jumpers be
reconfigured. See “Video jumpers,” earlier in this chapter.
Input only sync signals (no video signals) on the H/V
and V BNCs.
For RGBHV video, use the R, G, B, H/HV, and V BNCs.
R G B H/HV V
For RGBS video, use the R, G, B, and H/HV BNCs.
R G B H/HV V
For component video, use the R (R-Y), G (Y), and B (B-Y) BNCs.
R G B H/HV V
For S-video, use the R (C-chroma) and G (Y-luma) BNCs.
R G B H/HV V
For composite video, use the G BNC. For three separate
genlocked video signals, use the R, G, and B BNCs.
R
-or- -or-
G B H/HV V
The TP T 15HD AV is backwards compatible with the
TP T 15HD A and the TP T BNC DA4.
However, the TP T 15HD A and the TP T BNC DA4
(products whose part numbers end in -02) are not
forward compatible with the TP T 15HD AV (whose
part number ends in -03).
Transmitted signal cabling
CAUTION
Do not connect this device to a computer data or
telecommunications network
RJ-45 termination must comply with the
TIA/EIA T 568A wiring standards for all connections.
10
RGB video transmission connector — Attach one end of a TP
cable to this RJ-45 female connector. Attach the other end to an
Extron TP BNC receiver.
11
Composite video transmission connector — Attach one end of
a TP cable to this RJ-45 female connector. Attach the other end
to an Extron TP composite video receiver.
2-252-24