Filter
Top Products
TP T 15HD 45 and TP T A 45 • Quick Start Guide
Quick Start Guide — TP T 15HD/A 45, cont’d
TP T 15HD 45 and TP T A 45 • Table of Contents
Chapter 1 • Introduction ..........................................................1-1
Features ......................................................................................1-2
Chapter 2 • Installation .............................................................2-1
Rear Panel Connectors ........................................................2-2
Front Panel Connectors and Indicators ......................2-5
Cabling and Setup .................................................................2-5
Compatibility with other Extron products ............................ 2-6
Cable testing ..........................................................................2-7
Skew delay problems .............................................................2-8
Mounting ................................................................................2-8
Appendix • Reference Information .................................. A-1
Specifications ......................................................................... A-2
Parts Lists ................................................................................. A-5
Included parts ........................................................................ A-5
Optional accessories ............................................................. A-5
Table of Contents
68-924-01 Rev. B
Printed in the USA
09 04
All trademarks mentioned in this manual are the properties of their respective
owners.
i
Step 5
If the TP T A 45 is being installed, connect the TP T A 45 to the
TP T 15HD 45. See Rear Panel Connectors in chapter 2.
The TP T 15HD 45 may be used as a stand-alone video module
only without the TP T A 45.
The TP T A 45 derives its power from the TP T 15HD 45.
Step 6
Connect and power up all input and output devices, then apply
power to the TP T 15HD 45 power supply and test for the display
and/or audio outputs. If a problem is encountered, check all
connections before proceeding further.
Step 7
If the previous display and/or audio test was successful, power off
and disconnect all equipment, detach cables, and install the TP T
15HD 45 and TP T A 45 (if installed) modules. See Mounting in
chapter 2.
If the transmitter is to be wall-mounted and the power supply
will be inaccessible, power must be applied to the
transmitter’s power supply before final mounting.
Step 8
Connect all device and power cables. Power up all input and output
devices, apply power to the transmitter and receiver, and test for the
display and/or audio.
QS-2