Filter
Top Products
2-7
PVT Series (Rack Mount Models) • Installation
a
Dual color power LED — This LED lights amber when
power only (no signal) is applied to the PVT, and green
when power and a signal are both present.
b
Auto switch LED (P�T SW RGB only) — This LED
lights green when the unit is in auto switch mode.
c
Input selection button with LED (P�T SW RGB only) —
Press these buttons to select (switch) between inputs
1 and 2. The associated LEDs lights green when
the input has an active video signal connected, and
amber when there is no signal present.
d
Dual configuration dual DIP switch (P�T SW RGB only) —
The left DIP switch allows the user to
select the switching mode, and the right
DIP switch allows the user to configure
the local monitor output from the rear
panel.
Switching mode (left DIP switch):
Set the switch up to Auto for automatic switching of the inputs
with an active signal.
N
When turning off auto switching, the PVT goes back to
the input that was selected prior to turning the auto-
switching on.
Set the switch down to Manual for front panel input switching
or input switching by contact closure control.
N
In Auto mode, if both inputs have an active signal,
Input 1 has priority.
Local monitor output (right DIP switch):
Set the switch up to Follow for automatic switching of the local
monitor output to the current selected input.
Set the switch down to Input 1 for local monitor output of the
signal from input 1 only.
1
AUTO
SWITCH
FOLLOW
AUTO
INPUT 1
MONITOR
MANUAL
ON