![](http://pdfasset.owneriq.net/d/02/d02d535b-eeb2-48a4-bf7c-1e2125f3fa4c/d02d535b-eeb2-48a4-bf7c-1e2125f3fa4c-bg11.png)
2-4
Installation, cont’d
PVT Series (Rack Mount Models) • Installation
2-5
PVT Series (Rack Mount Models) • Installation
Furniture mounting
Use the optional mounting kit (MBU 123, under desk mounting
kit, part #70-212-01) to mount the PVT as follows:
1. If installed, remove the feet from the bottom of the PVT.
2. Attach the mounting brackets to the PVT with the machine
screws provided (figure 2-3).
Figure 2-3 — Mounting the PVT under a desk
3. Hold the PVT with the attached brackets against the
underside of the mounting surface. Mark the bracket
screw hole locations on the mounting surface.
4. Drill four 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked locations.
5. Insert #8 wood screws into the pilot holes. Tighten the
screws until just less than 1/4" of the head protrudes.
6. Align the mounting screws with the slots in the brackets
and place the PVT against the surface, with the screws
through the bracket slots.
7. Slide the PVT slightly forward or back, then tighten all
four screws to secure the PVT in place.
To rack mount a PVT transmitter, do the following:
1. If installed, remove the feet from the bottom of the PVT.
2. Mount the PVT using two 4-40 x 3/16" screws in opposite
(diagonal) corners to secure the PVT to the shelf.
3. Install blank panel(s) or other unit(s) to the rack shelf.
VersaTools
Rack Shelf
(2) 4-40 x 3/16"
Screws
Quarter and Eighth
Rack Width False
Front Face Plate
Quarter Rack
Width Device
Eighth Rack
Width Device
Figure 2-1 — Mounting the PVT on a VersaTools rack
shelf
M
D
A
S
E
R
IE
S
D
I
S
T
R
I
B
U
T
I
O
N
A
M
P
L
I
F
I
E
R
Quarter Rack
Width Device
Eighth Rack
Width Device
Figure 2-2 — Mounting the PVT on a standard rack
shelf