Filter
Top Products
4-3
MP 101 Series • MP 101 D
N
Do not tin the stripped power supply leads before
installing the captive screw connector. Tinned wires are
not as secure in the captive screw connectors and could
pull out.
W
The two power cord wires must be kept separate while
the power supply is plugged in. Remove power before
continuing.
Audio output (line level)
b
Phantom power switch — Provides switchable 48 volt phantom
power for condenser microphones.
c
Line Output — A 3-pin, captive screw connector outputs to
audio mixers, amps switchers, or other non-microphone audio
equipment.
Tip
Sleeve
NO Ground Here
CAUTION
For unbalanced audio, connect the sleeve(s)
to the ground. DO NOT connect the sleeve(s)
to the negative (-) contact.
(5 mm) MAX
Captive Screw
Connector stripping
3/16"
Tip
Sleeve
Ring
d
Low Cut fi lter switch — Provides low cut fi ltering to remove
wind and “table rumble” noise.
Remote connection
e
Remote — An optional 3-pin, captive screw connector allows
a wall mounted audio controller or MediaLink product to
remotely control volume and mute levels for the MP 101
unit. See “Remote Control”, later in this chapter, for more
information.