Filter
Top Products
3-5
MP 101 Series • MP 101 AAP
level that is free of distortion.
N
If there is a remote control connection, unplug it while
adjusting the Mic Gain potentiometer. Replace the remote
control when fi nished.
4. If there is minimal distortion, but greater volume is
required, turn the Mic Gain potentiometer clockwise
(towards the 75 dB mark) to increase the volume, but not
past the point where distortion occurs.
Mounting the MP 101 AAP
The MP 101 AAP must be attached to a device faceplate or AAP
wallplate and then cabled before you can test and perform the
fi nal mount (installation into a wall or piece of furniture).
N
Before mounting, the MP 101 AAP should be tested to
verify that its connections and settings are correct.
To mount the MP 101 AAP into a device faceplate or AAP
wallplate, do the following:
1. Before any cables are attached, insert the MP 101 AAP’s
standoffs through the holes in the device’s faceplate or
AAP wallplate.
2. Secure all cables and connections into the rear connectors
of the MP 101 AAP.
3. Using the provided #4-40 nuts and captive washers, secure
the preamplifi er to the faceplate or wallplate, as shown
below.
Extron
MP 101 AAP
MIC to Line
Preamplifier
Installation Cable
Cable
Clamp
Screws or Nails
Wall Stud
Extron
AAP 102
AAP 102
#4-40 Nut w/ Captive
Washer
MIC
IN
MLP 101 AAP
MUTE
ACTIVE